Yamaha RX-V3800 owner manual Clearing configurations, 114 En, Clearing function sets

Remote control features

Clearing configurations

You can clear all changes made in each function set, such as learned functions, macros, renamed input area names and setup remote control ID.

■Clearing function sets

1Set the operation mode selector to DAMP or DSOURCE and then press MCLEAR by

using a ballpoint pen or similar object.

“CLEAR” appears in the display window (B).

AMP

SOURCE

TV

CLEAR

or

AMP

SOURCE

TV

3Press and hold MCLEAR again for about 3 seconds.

“WAIT” appears in the display window (B). If clearing was successful, “C;OK” appears in the display window (B) on the remote control.

CLEAR

y

Once you have cleared a learned function for a button, the button reverts to the factory setting (or to the manufacturer setting, if you have set remote control codes).

Notes

•“L;ALL” and “FCTRY” may take about 30 seconds to complete.

•“C;NG” appears in the display window (B) if clearing was unsuccessful. In this case start over from step 2.

•“ERROR” appears in the display window (B) if you press a button not indicated in the respective step, or if you press more than one button simultaneously.

Note 4 Press MCLEAR again to exit.

If you do not complete each of the following steps within 30 seconds, the clearing mode will be automatically canceled. In this case, start over from step 1.

2Press 4k / n to select the clear mode.

L;CD (etc.) (L; Name of an input area) Clears all learned functions in the respective input area. The name of a component is shown after a semicolon (;).

	Press an input selector button to select the input
	area.
L;AMP	Clears all learned functions for controlling the
	amplifier functions of this unit.
L;ALL	Clears all learned functions.
M;ALL	Clears all programmed macros.
RNAME	Clears all renamed source names.
FCTRY	Clears all remote functions and returns the
	remote to the factory settings.
	PRESET/CH
	ENTER
	A-E/CAT.

114 En