Yamaha RX-V3800 125 En, Remote control XM ID RC XM ID U.S.A. and Canada models only, Press 4ENTER

■ Remote control XM ID RC XM ID

(U.S.A. and Canada models only)

Use this feature to set the XM ID of this unit for remote control recognition.

Choices: ID1, ID2

•Select “ID1” when the remote control XM ID library code is set to “2604”.

•Select “ID2” when the remote control XM ID library code is set to “2605”.

Setting remote control XM ID

1Set the operation mode selector to DAMP or DSOURCE and then press 1XM on the

remote control to select the XM to change the remote control ID.

2Press and hold MLEARN for about 3 seconds using a ballpoint pen or similar object until “L;TUN” and “XM” alternately appear in the display window (B) on the remote control.

LEARN

3 seconds

Notes

•Be sure to press and hold MLEARN for at least 3 seconds, otherwise the learning process will start.

•If you do not complete each of the following steps within 30 seconds, the setting mode will be automatically canceled. In this case, start over from step 2.

Advanced setup

4Press the numeric buttons (6) to enter the four-digit remote control code for the input area you want to use.

Remote
control XM	Function	RC XM ID*2
ID code*1
2604	Operates this unit using the	ID1
(initial setting)	default code.	(initial setting)
2605	Operates this unit using an	ID2
	alternative code.

*1 The remote control setting.

*2 The setting of this unit.

5Press 4ENTER to set the number.

“OK” appears in the display window (B) if the setting was successful.

“NG” appears in the display window (B) if the setting was unsuccessful. In this case, start over from step 2.

6Press MLEARN again to exit from the setup mode.

LEARN

See page 122 for the operation of the advanced setup.

OPERATION ADVANCED

3Press 4ENTER.

The four-digit code set for the selected input area appears in the display window (B) on the remote control.

English

125 En