Yamaha RX-V4600 owner manual Speaker impedance setting, Turning on the power

CONNECTIONS

Speaker impedance setting

Follow the procedure below to change the impedance setting for all speakers.

CAUTION

If you are using 6 ohm speakers, set the impedance to 6 ohms before using this unit.

Be sure this unit is in the standby mode.

1On the front panel, while holding down

STRAIGHT/EFFECT, press STANDBY/ON.

“SP IMP.–8ΩMIN” appears on the front panel display.

Turning on the power

When all connections are complete, turn on the power of this unit.

1

										PURE DIRECT
										VOLUME
	AUDIO	MULTI CH		PRESET/		PRESET/			TUNING	TONE
	SELECT	INPUT	A/B/C/D/E	TUNING		TUNING	FM/AM	MEMORY	MODE	STRAIGHT CONTROL
	INPUT					EDIT		MAN'L/AUTO FM	AUTO/MAN'L	EFFECT
		SOURCE/	SPEAKERS				ZONE ON/OFF	ZONE CONTROL
	DVD REMOTEMD/TAPE									PROGRAM
	DTV	CD-R
	CBL/SAT	TUNER	A	B		MAIN	ZONE 2	ZONE 3
STANDBY	VCR 1	CD		SILENT CINEMA	S VIDEO	VIDEO	L AUDIO R		OPTICAL
/ON	DVR/
	VCR 2
	REC OUT/ZONE 2		OPTIMIZER	PHONES
			MIC			VIDEO/AUX

STRAIGHT

EFFECT

STANDBY

/ON

			SYSTEM	1
POWER	POWER	STANDBY	POWER
TV	AV
A	B	AUDIO SELECT	SLEEP
PHONO	TUNER	CD	MULTI CH IN
V-AUX	CBL/SAT	MD/TAPE	CD-R
DTV	VCR 1	DVR/VCR2	DVD

SELECT

SP IMP.-8 MIN

2Press STRAIGHT/EFFECT to select the impedance of your speakers.

If you are using 6 ohm speakers, select 6 ohms; if you are using 8 ohm speakers, select 8 ohms.

3Press STANDBY/ON to exit the setting.

This unit will be set to the standby mode.

Note

Speaker impedance setting function is located in the Advanced menu (see page 86).

AMP

+ + +

1Press STANDBY/ON (or SYSTEM POWER on the remote controls) to turn on the power of this unit.

SYSTEM

POWER

STANDBY

/ONor

Front panel Remote control

2Turn on the video monitor connected to this unit.

Note

Press STANDBY/ON again (or STANDBY on the remote control) to enter the standby mode.

26