Yamaha RX-V4600 owner manual Changing parameter settings, Manual Setup Basic Speaker Set

SYSTEM OPTIONS

Changing parameter settings

Use the remote control to access and adjust each parameter. (Speaker set is used in the following example to change parameter settings.)

Manual Setup > Basic > Speaker Set >

	+	+	+	AMP
					1
	TV VOL	CH	VOL	SOURCE
	–	–	–	TV
	TV MUTE	TV INPUT	MUTE
1	TOP	PRESET	EXIT	PURE DIRECT	5
	TITLE		MENU
	BAND		PRG SELECT
				NIGHT
		ENTER		AUDIO	2-4
			A/B/C/D/E
				STRAIGHT
	RETURN		DISPLAY
				EFFECT

3Press k / n repeatedly to select the parameter you want to adjust.

Presence	40Hz
Bass Out	60Hz
Bass Cross Over	80Hz (THX)
SWFR Phase	90Hz
	100Hz

4Press ENTER or h, then press k / n repeatedly to change the setting of the item you want to adjust.

1Set AMP/SOURCE/TV to AMP, then press TOP on the remote control.

The top display appears.

AMP	TOP
SOURCE	TITLE
TV

Presence	40Hz
Bass Out	60Hz
Bass Cross Over	80Hz (THX)
SWFR Phase	90Hz
	100Hz

Stereo/Surround
Input Select	Sound
Manual Setup	Basic
Auto Setup	Option
System Memory

2Press k / n repeatedly to select a menu, then press h to enter the selected menu.

Test Tone
Speaker Set	Front
Speaker Distance	Center
Speaker Level	Surround

Front
Center	Large
Surround	Small
Surround Back	None
Presence

5Press EXIT.

y

If you want to continue adjusting parameter settings, press ENTER to return to the previously selected menu item.

Notes

•The available parameters may be displayed on more than one page of the GUI display. To scroll through pages, press k / n.

•You cannot change parameter values when Memory Guard is set to “On”. If you want to change the parameter values, set Memory Guard to “Off” (see page 68).

Memory back-up

The memory back-up circuit prevents the stored data from being lost even if this unit is set in the standby mode, the power cable is disconnected from the AC outlet, or the power supply is temporarily cut due to power failure. However, if the power is cut for more than one week, the parameter values will return to the factory settings. If this happens, edit the parameter value again.

54