Yamaha RX-V4600 Rename Rename, Multi CH Assign Multi channel assignment, Input Channels

■Rename (Rename)

Use this feature to change the name of the inputs in the GUI or the front panel display menu. (DVD is used as the source component in the following example.)

Input Select > input source (DVD, etc.) > Rename

1Press an input selector button to select the input you want to change the name of.

2Press l / h to place the _ (under-bar) under the space or character you want to edit.

Decoder Mode
Volume Trim		CAPITAL
Rename	DVD
	OK	RESET

3Press ENTER to select a character type (CAPITAL/SMALL/FIGURE/MARK).

4Press k / n to select the character you want to use and l / h to move to the next one.

•You can use up to 8 characters for each input.

•Press n to change the character in the following

order, or press k to go in the reverse order. Press ENTER to switch between character types:

CAPITAL	A to Z, space
SMALL	a to z, space
FIGURE	0 to 9, space
MARK	!, #, %, &, etc.

• Repeat steps 1 to 3 to rename each input.

5Press l / h to select OK and press ENTER when complete.

y

•To change source names in the display window on the remote control, see page 75.

•This menu item is also available in the changing source names in the display window feature (see page 75), and in the front panel display system options menu (see page 89).

Note

You can only change the name of the current input source (except for multi channel input sources) using this setting.

SYSTEM OPTIONS

■Multi CH Assign

(Multi channel assignment)

Use this feature to set the direction of the signals input into the center, subwoofer and surround channels when a source component is connected to the MULTI CH INPUT jacks. If you are inputting 8-channel signals from an external decoder, use this feature to select jacks for the additional front signals.

Input Select > MULTI CH > Multi CH Assign >

Volume Trim

Multi CH Assign Input Channels

Front Input

Input Channels

This setting is used to select the number of channels input from an external decoder.

Choices: 6ch, 8ch

Note

If Zone2 Amplifier (page 67) is set to “Internal”, no sound is output from the surround back speakers even if you select “8ch”. In this case, select “6ch” and set the output setting of the external component to 6 channels.

Front Input

If you selected “8ch” in Input Channels, you can select analog jacks at which front signals from an external decoder will be input.

Choices: DVD, DTV, CBL/SAT, VCR1, DVR/VCR2, V-AUX, CD, CD-R, MD/TAPE

y

This menu item is also available in the front panel display system options menu (see page 89).

OPERATION ADVANCED

57