Yamaha RX-V4600 i.LINK display messages, Status display messages, Error messages, Link Check

USING i.LINK

i.LINK display messages

■Status display messages

The following messages may appear on the front panel display depending on the status of this unit.

Message	Contents
LINK CHECK	Flashes while the i.LINK component connection is being checked.*

*Playback may stop while this message is displayed.

■Error messages

The following messages appear on the front panel display if a connection or registration error is detected.

Message	Cause	Remedy
BUS FULL	The 1394 bus transmission band is full, and no	This problem may be resolved by disconnecting any
	more data can be transmitted.	unused i.LINK components.
		If an i.LINK component with a slow transmission speed
		(S100 or S200) is connected between this unit and the
		i.LINK (AUDIO) component which you want to play
		back, the bus may become full. Changing the
		connection order of the i.LINK components so that this
		unit and the i.LINK (AUDIO) component are directly
		connected may resolve this problem.
CANNOT LINK	The connected i.LINK component is not	Check that all i.LINK components are connected
	recognized because the connection is	properly using an IEEE1394 cable.
	incomplete.
LOOP CONNECT	This unit and the i.LINK component are	Disconnect the IEEE1394 cable, then reconnect it in
	connected in a loop (where the output signal is	either a daisy chain or tree configuration.
	returned to the original component).
NODE OVER	More than 63 i.LINK components (including	Reduce the number of connected components.
	this unit) are connected.
HOP OVER	More than 15 i.LINK components are	Reduce the number of i.LINK components connected
	connected in a daisy chain configuration.	between the two end components to 15 or less.
		Reconnect the i.LINK components using tree-type
		connections.
REGIST. OVER	A new i.LINK component is connected to this	Delete any unused registered i.LINK components from
	unit while 16 i.LINK components are already	the registered components list and reconnect the
	registered. This unit can register up to 16	i.LINK component you want to register.
	i.LINK components.	See “Changing i.LINK Select parameters” on page 92.

■i.LINK indicator

Lights up	When an i.LINK component is connected, and this unit is playing back signals input via
	i.LINK connections.
Flashes	When an i.LINK component is connected, but this unit is playing back signals input via
	connections other than i.LINK or no signals are being input via i.LINK connections.
Off	When no i.LINK component is connected.

94