Yamaha RX-V4600 owner manual Basic i.LINK operations, Changing i.LINK Select parameters

USING i.LINK

Basic i.LINK operations

■Assigning i.LINK components

When an i.LINK component is connected, this unit automatically recognizes the connection and registers up to 16 i.LINK components. Assigning an i.LINK component to a specific input allows you to select video and audio input signals from that component received via the i.LINK connection for simultaneous playback.

Turn on the power of this unit and the connected i.LINK component.

The i.LINK component is automatically recognized and registered in the following order:

DVD → DTV → CBL/SAT → VCR1 → DVR/VCR2 → V-AUX → PHONO → CD → CD-R → MD/TAPE “LINK CHECK” flashes on the front panel display during this procedure.

Notes

•If you want to change the input assignment of a registered i.LINK component, use Input Assign in the GUI menu (see page 93) or INPUT ASSIGN in the front panel display system options menu (see page 90).

•Only one i.LINK component is assigned to each input and inputs that are already assigned are skipped.

•If i.LINK components are assigned to all the inputs available, no more i.LINK components can be assigned, and audio signals input from these i.LINK components cannot be played back on this unit.

■Listening to playback from i.LINK

components

If an i.LINK component has been assigned to a specific input, perform the following steps to listen to playback from the registered i.LINK component.

1Rotate the INPUT selector to select the input assigned to the i.LINK component.

2Press AUDIO SELECT repeatedly to set “AUTO” or “i.LINK” as the input mode.

	DVR/VCR2		CBL/SAT			MD/TAPE
V-AUX		VCR 1		DTV	DVD		CD-R	CD	TUNER	PHONO
		SP
		A								dB
		A.SEL:AUTO								VOLUME
										L R
				or
	DVR/VCR2		CBL/SAT			MD/TAPE
V-AUX		VCR 1		DTV	DVD		CD-R	CD	TUNER	PHONO
		SP
		A								dB

VOLUME

A.SEL:i.LINK L R

3Start playback on the connected i.LINK component.

Notes

•You can turn on/off automatic playback when an i.LINK component is selected using the INPUT selector or to select whether you want the input to switch automatically when an input stream from a connected i.LINK component is detected (see page 93).

•Audio signals input at the i.LINK jacks are digitally output only when AUDIO SELECT is set to either AUTO or i.LINK as the input mode and REC OUT/ZONE 2 on the front panel is set to

SOURCE/REMOTE.

Changing i.LINK Select parameters

Use this menu to display information about registered i.LINK components, delete any unused registered components, or customize the operation and playback settings to be used when this unit is connected to an i.LINK component.

1Switch on this unit and video monitor.

2Set AMP/SOURCE/TV to AMP, then press TOP on the remote control.

The top display appears.

AMP	TOP
SOURCE	TITLE
TV

Stereo/Surround
Input Select	Sound
Manual Setup	Basic
Auto Setup	Option
System Memory

3Press k / n repeatedly to select i.LINK Select.

HDMI	Information
i.LINK Select	Information
Stereo/Surround	Select
Input Select	Auto Play

4Press ENTER or h, then press k / n repeatedly to change the setting of the item you want to adjust.

5Press EXIT.

92