Yamaha RX-V4600 owner manual Remote control, Problem, Cause, Remedy, Refer to

TROUBLESHOOTING

■Remote control

Problem	Cause	Remedy	Refer to
			page
The remote control	Wrong distance or angle.	The remote control will function within a maximum	9
does not work or		range of 6 m (20 ft) and no more than 30 degrees off-
function properly.		axis from the front panel.
	Direct sunlight or lighting (from an	Reposition this unit.
	inverter type of fluorescent lamp, etc.) is		—
	striking the remote control sensor of this
	unit.
	The batteries are weak.	Replace all batteries.	4
	AMP/SOURCE/TV is set incorrectly.	Set AMP/SOURCE/TV correctly.
		When operating this unit, set it to the AMP position.
		When operating the component selected by the input	—
		selector button, set it to the SOURCE position.
		When operating the TV set in the DTV or PHONO
		area, set it to the TV position.
	The remote control code was not correctly	Set the remote control code correctly using	71
	set.	“LIST OF REMOTE CONTROL CODES” at the end
		of this manual.
		Try setting another code of the same manufacturer	71
		using “LIST OF REMOTE CONTROL CODES” at
		the end of this manual.
	This unit’s library code and the remote	Switch the library code.	71
	control ID do not match.
	Even if the remote control code is	Program the necessary functions independently into	73
	correctly set, there are some models that	the programmable buttons using the Learn feature.
	do not respond to the remote control.
The remote control	The batteries of this remote control and/or	Replace the batteries.	4
does not “learn” new	the other remote control are too weak.
functions.
	The distance between the two remote	Place the remote controls at the proper distance.	73
	controls is too much or too little.
	The signal coding or modulation of the	Learning is not possible.	—
	other remote control is not compatible
	with this remote control.
	Memory capacity is full.	Delete other unnecessary functions to make room for	78
		the new functions.

INFORMATION ADDITIONAL

109