Yamaha RX-V4600 owner manual Clearing a macro function, Press Clear to exit the clearing mode

REMOTE CONTROL FEATURES

4Press and hold CLEAR using a ballpoint pen or similar object, then press the button you want to clear for about 3 seconds.

“C;OK” appears in the display window if clearing was successful.

FREQ/RDS EON MODE PTY SEEK START

REC

DISC SKIP

OFF ON MACRO LEARN CLEAR RE–NAME

3Press and hold CLEAR using a ballpoint pen or similar object, then press the macro button you want to clear for about 3 seconds.

“C;OK” appears in the display window if clearing was successful.

DTV VCR 1 DVR/VCR2 DVD

REC

DISC SKIP

OFF ON MACRO LEARN CLEAR RE–NAME

y

•If you continuously want to clear another function, repeat step 4.

•If you continuously want to clear another function for another component, press SELECT k / n to select the component, then repeat step 4.

•Once you clear a learned function, the button reverts to the factory setting (or to the manufacturer setting if you have set remote control codes).

5Press CLEAR to exit the clearing mode.

The remote control returns to the learning mode.

6Press LEARN again to exit.

Notes

•“C;NG” appears in the display window if clearing was unsuccessful. In this case, start over from step 4.

•“ERROR” appears in the display window if you press a button not indicated in the respective step, or if you press more than one button simultaneously.

■Clearing a macro function

You can clear the function programmed for a certain macro button.

1Set AMP/SOURCE/TV to AMP or SOURCE.

AMP

SOURCE

TV

2Press MACRO using a ballpoint pen or similar object.

“MCR ?” appears in the display window.

MACRO

Note

If you do not complete each of the following steps within 30 seconds, the macro programming mode will be automatically canceled. In this case, press MACRO again.

y

•If you continuously want to clear another function, repeat step 3.

•Once you clear a programmed function, the button reverts to the factory setting (or to the manufacturer setting if you have set remote control codes).

4Press CLEAR to exit the clearing mode.

The remote control returns to the macro programming mode.

5Press MACRO again to exit.

Notes

•“C;NG” appears in the display window if clearing was unsuccessful. In this case, start over from step 3.

•“ERROR” appears in the display window if you press a button not indicated in the respective step, or if you press more than one button simultaneously.

80