Yamaha RX-V4600 owner manual Press Learn again to exit from the setup mode, To 10 cm 2 to 4

7Press LEARN again to exit from the setup mode.

LEARN

8Press one of the buttons shaded below to see if you can control your component. If you can, the remote control code is correct.

			SYSTEM
POWER	POWER	STANDBY	POWER
TV	AV			FREQ/RDS	EON	MODE	PTY SEEK START
A	B	AUDIO SELECT	SLEEP	REC
				DISC SKIP
PHONO	TUNER	CD	MULTI CH IN	OFF ON	MACRO	LEARN	CLEAR RE–NAME
V-AUX	CBL/SAT	MD/TAPE	CD-R
DTV	VCR 1	DVR/VCR2	DVD

y

If the manufacturer of your component has more than one code, try each of them until you find the correct one.

Notes

•“ERROR” appears in the display window if you press a button not indicated in the respective step, or when you press more than one button simultaneously.

•The supplied remote control does not contain all possible codes for commercially available audio and video components (including YAMAHA components). If operation is not possible with any of the remote control codes, program the new remote control function using the Learn feature (see “Programming codes from other remote controls (Learn)”) or use the remote control supplied with the component.

•Function programmed using the learn feature take priority over remote control code functions.

REMOTE CONTROL FEATURES

Programming codes from other remote controls (Learn)

Use the learn feature if you want to program functions not included in the basic operations covered by remote control codes, or an appropriate remote control code is not available. You can program any of the buttons available in the component control area (see page 70). The buttons can be programmed independently for each component.

Note

This remote control transmits infrared rays. If the other remote control also uses infrared rays, this remote control can learn most of its functions. However, you may not be able to program some special signals or extremely long transmissions. (Refer to the operating instructions for the other remote control.)

1Set AMP/SOURCE/TV to SOURCE.

AMP

SOURCE

TV

2Press an input selector button to select a source component.

A	B	AUDIO SELECT	SLEEP
PHONO	TUNER	CD	MULTI CH IN
V-AUX	CBL/SAT	MD/TAPE	CD-R
DTV	VCR 1	DVR/VCR2	DVD

3Place this remote control about 5 to 10 cm (2 to 4 in) apart from the other remote control on a flat surface so that their infrared transmitters are aimed at each other.

	DTV	AUX	PHONO	A	TV	POWER
		V
		-
	VCR 1	CBL/SAT	TUNER	B	AV	POWER
	DVR/VCR2	MD/TAPE	CD	AUDIO SELECT		STANDBY
SELECT	DVD	CD-R	MULTI CH IN	SLEEP		SYSTEM POWER

5 to 10 cm (2 to 4 in)

OPERATION ADVANCED

73