Yamaha RX-V4600 owner manual Changing source names in the display window

REMOTE CONTROL FEATURES

Changing source names in the display window

You can change the name that appears in the display window on the remote control if you want to use a different name than the factory preset. This is useful when you have set the input selector to control a different component.

1Set AMP/SOURCE/TV to AMP or SOURCE.

AMP

SOURCE

TV

5Press l / h to move the cursor to the next position.

PRESET

ENTER

A/B/C/D/E

6Press ENTER to set the new name.

“OK” appears in the display window if renaming was successful.

“NG” appears in the display window if renaming was unsuccessful. In this case, start over from step 4.

		y
2 Press an input selector button to select the		If you continuously want to rename another component,
source component you want to rename.		press the input selector button or SELECT k / n to select
		the component, then repeat steps 4 through 6.
The selected component name appears in the display
window.
		7 Press RE-NAME again to exit the renaming
A	B AUDIO SELECT SLEEP
		mode.

PHONO	TUNER	CD	MULTI CH IN
			RE-NAME
V-AUX	CBL/SAT	MD/TAPE	CD-R
DTV	VCR 1	DVR/VCR2	DVD

Note

	“ERROR” appears in the display window if you press a button
3 Press RE-NAME using a ballpoint pen or	not indicated in the respective step, or when you press more than
similar object.	one button simultaneously.
RE-NAME

Note

If you do not complete each of the following steps within 30 seconds, the renaming mode will be automatically canceled. In this case, press RE-NAME again.

4Press k / n to select and enter a character.

Pressing n changes the character as follows:

A to Z, 1 to 9, 0, + (plus), – (hyphen), ; (semicolon),

/ (slash), and space.

(Pressing k changes the characters in reverse order.)

PRESET

ENTER

A/B/C/D/E

OPERATION ADVANCED

75