Yamaha RX-V4600 owner manual Controlling Zone 2/Zone 3 from the front panel

ZONE 2/ZONE 3

Using this unit’s internal amplifier

To use this unit’s internal amplifier, select “Internal” in Zone2 Amplifier 2 (page 67).

RL

+

–

PRESENCE/ ZONE 2

Second room

This unit

Controlling Zone 2/Zone 3 from the front panel

You can control the input or adjust the volume level for Zone 2 and Zone 3 components using ZONE CONTROL on the front panel.

1Set REC OUT/ZONE 2 on the front panel to

SOURCE/REMOTE.

	SOURCE/
DVD REMOTE MD/TAPE
DTV	CD-R
CBL/SAT	TUNER
VCR 1	CD
DVR/
VCR 2

REC OUT/ZONE 2

2Press MAIN, ZONE 2 or ZONE 3 to select the zone you want to change the input for or adjust the volume level.

ZONE ON/OFF

MAIN ZONE ZONE 3

Press each button repeatedly to turn the respective zone on or off.

You can choose from the following modes:

ZONE2 Controls the Zone 2 component connected to the ZONE 2 AUDIO L/R jacks on this unit.

ZONE3 Controls the Zone 3 component connected to the ZONE 3 AUDIO L/R jacks on this unit.

MAIN Controls the main component (this unit).

3Press ZONE CONTROL on the front panel repeatedly to choose the zone you selected in step 2.

ZONE CONTROL

Each time you press ZONE CONTROL, the front panel display changes as shown below, and the indicator for the currently selected zone flashes for approximately 5 seconds.

ZONE 2 ZONE 3

MAIN

y

•You must complete this step within 5 seconds of pressing ZONE CONTROL on the front panel. Otherwise, the zone mode selection process is automatically canceled.

In this case, press ZONE CONTROL again.

•The initial setting is “ZONE 2” when both the Zone 2 and Zone 3 components connected to this unit are turned on.

•If you selected MAIN in step 2, no indicator flashes on the front panel display when ZONE CONTROL is pressed.

4Use the INPUT or VOLUME selector on the front panel to switch the input or adjust the volume level for the selected zone component.

VOLUME

INPUT

or

y

You must complete this step within 5 seconds of performing step 2. Otherwise, the zone mode selection process is automatically canceled. In this case, repeat steps 2 and 3 again.

OPERATION ADVANCED

83