Connecting to an IBM PC/AT Series Computer

Connect the TO HOST connector of the VL70-m to the RS-232C port on your IBM computer, using a standard 8-pin MINI DIN → 9-pin D-SUB cross cable. Set the TO HOST selector to the “PC-2” position.

Refer to your software owner’s manual for information on any settings you might have to make on the computer side.

●“PC-2” Cable Connections

mini Din 8-pin

D-SUB 9-pin

•8-pin mini DIN → 9-pin D-SUB cable. Use a “PC-1” type cable if your computer uses a 25-pin serial port.

•Data transfer rate: 38,400 bps.

Connecting to an NEC PC-9801/9821 Series Computer

The NEC PC-9801/9821 computers are widely used in Japan. Connect the TO HOST connector of the VL70-m to the RS-232C port on your NEC computer, using a standard 8-pin MINI DIN → 25-pin D-SUB cross cable. Set the TO HOST selector to the “PC-1” position.

Refer to your software owner’s manual for information on any settings you might have to make on the computer side.

■NOTES

•If your system doesn’t work properly with the connections and settings listed above, your software may require different settings. Check your software operation manual and set the HOST SELECT switch to the position the provides the appropriate data transfer rate.

●“PC-1” Cable Connections

mini Din 8-pin

D-SUB 25-pin

•8-pin mini DIN → 25-pin D-SUB cable. Use a “PC-2” type cable if your computer uses a 9-pin serial port.

•Data transfer rate: 31,250 bps.

Setting Up 21