The Chorus Parameters

The VL70-m chorus stage actually includes a number of modulation-type effects that can be used to give your sound extra animation and life.

Type

•Chorus Type

•Settings: NO EFFECT, CHORUS 1, CHORUS 2, CHORUS 3, CELESTE 1, CELESTE 2, CELESTE 3, FLANGER 1, FLANGER 2, SYMPHONIC, PHASER

right, and “C” places the sound in the center. Intermediate settings pan the chorus sound to corresponding positions in the stereo sound field.

Selects the chorus type, or “NO EFFECT” if no chorus effect is required. Refer to the separate “List Book” for brief descriptions of each of the chorus types.

Type-Specific Chorus Parameters

•See separate “List Book”

Each of the chorus types, selected via the “Type” parameter, above, has a different set of parameters that specify the actual chorus sound. Refer to the separate “List Book” for information on the individual parameters for each chorus type.

SendCho➔Rev

•Chorus-to-Reverb Send Level

•Settings: 000 … 127

Sets the amount of signal sent from the output of the chorus effect stage back to the input of the reverb effect stage (see diagram on pages 86 and 87). The higher the value, the more chorus signal is sent to the reverb stage. If this parameter and the PLAY mode “ChoRtn” parameter are both set to values higher than “001”, the output of the chorus stage will be sent in corresponding amounts to the input of the reverb stage and the main outputs.

Cho Pan

•Chorus Pan

•Settings: L63 … C … R63

Sets the pan position of the chorus sound — i.e. the perceived position of the chorus sound within the stereo sound field. A setting of “L63” sets the chorus sound full left, “R63” sets the sound full

Effects & Effect Editing 91