24: EmbLowrDpt (VOICE mode only)

25: Emb Mode (VOICE mode only)

• Embouchure Lower Control Depth

• Embouchure Mode

• Settings: -127 … +127

• Settings: Cntr, Min

Sets the amount of variation produced by the controller assigned to embouchure when the controller is set to it minimum position (e.g. a modulation wheel rolled all the way down). The higher the value the greater the variation. Positive values cause an increase in embouchure in response to lower controller values, while minus values cause a decrease in embouchure in response to lower controller values. The “EmbLowrDpt” parameter has no effect when the “Emb Mode” parameter, below, is set to “Min”.

Selects the controller value (position) which will produce “normal” embouchure. When set to “Cntr” (Center) a central controller position will produce normal embouchure, allowing both downward and upward variation. A setting of “Min” (Minimum) will produce normal embouchure when the controller is set to its minimum position, allowing only upward variation.

●VL-XG MODE

In the VL-XG sound module mode (page 28) the “EmbUpprDpt” and EmbLowrDpt” parameters are replaced by a single “EmbCtrlDpt” parameter, as follows:

15: EmbCtrlDpt

•Embouchure Control Depth

•Settings: -64 … +63

Sets the amount of variation produced by the controller assigned to embouchure. The higher the value the greater the variation. Positive values cause an increase in embou- chure in response to higher controller values (e.g. increased breath pressure or higher modulation wheel position), while minus values cause an decrease in embouchure in response to higher controller values.

Tonguing26(16): Tng CC No.

•Tonguing Control Change Number

•Settings: off … 95, AT, VEL, PB

“Tonguing” simulates the half-tonguing technique used by saxophone players by changing the “slit” of the reed. The slit is the space between the tip of the reed and the mouthpiece. The “Tng CC No.” parameter specifies the controller to be used for tonguing control. When set to “off” no tonguing is applied.

•Please note that accurate keyboard pitch is produced only when maximum tonguing is applied or the tonguing controller is turned off.

•The “TngCtrlDpt” parameter, below, must be set to an appropriate value (higher than “+01” or lower than “-01”) for tonguing control to have any effect.

58Controllers & Control Editing