•Polyphonic Expansion will not function when the “06(05): Mono/Poly” parameter is set to “mono”.

•When using Polyphonic Expansion be sure to set the “07: AssignMode” parameter to “Last”.

The horizontal axis represents keyboard velocity and the vertical axis represents output level.

Note LimitsVelocity Sensitivity
09(06): VelSensDpt

no sound

note range

 

no sound

 

 

 

 

 

 

 

 

 

 

 

•Velocity Sensitivity Depth

•Settings: 000 … 127

Determines how the VL70-m responds to keyboard velocity. When set to “000”, keyboard velocity (i.e. how fast or hard the keyboard is played) has no effect on the sound. At values higher than “001”, however, high keyboard velocities will increase the level of the sound and low keyboard velocities will decrease the level of the sound. The higher the value the greater the effect of keyboard velocity on the voice level. The graph at the bottom of the display indicates the current velocity sensitivity response as determined by the “09(06): VelSensDpt” and “10(07): VelSensOfs” parameters. The horizontal axis represents keyboard velocity and the vertical axis represents output level.

Low note limit

High note limit

11(08): NoteLimitL

•Low Note Limit

•Settings: C-2 … G8

Specifies the lowest note that will be produced by the VL70-m. This and the “NoteLimitH” param- eter, below, specify the VL70-m note range.

12(09): NoteLimitH

•High Note Limit

•Settings: C-2 … G8

10(07): VelSensOfs

•Velocity Sensitivity Offset

•Settings: 000 … 127

Specifies an offset value that will apply to the lowest keyboard velocity level. The graph at the bottom of the display indicates the current velocity sensitivity response as determined by the “09(06): VelSensDpt” and “10(07): VelSensOfs” parameters.

Specifies the highest note that will be produced by the VL70-m. This and the “NoteLimitL” parameter, above, specify the VL70-m note range.

Other Edit Parameters 81