DevNo. (Device Number)

Settings: 001 … 016, all

The Device Number parameter must be set properly when you want to transmit or receive MIDI system exclusive data to or from another VL70-m or other MIDI device (system exclusive data includes voice parameters, system setup param- eters, etc). The VL70-m Device number must be set to the same number as the Device Number of the external device. Select a device number from “001” to “016”, or “all” . When “all” is selected, MIDI system exclusive data can be received on all device numbers, but transmission occurs via device number 001.

M.Volum (Master Volume)

Settings: 000 … 127

Sets the VL70-m master volume level. The higher the value the louder the volume.

RevRtn (Reverb Return)

Settings: 000 … 127

Adjusts the level of the signal returned from the VL70-m reverb effect stage. The higher the value, the higher the level of the reverb signal.

ChoRtn (Chorus Return)

Settings: 000 … 127

Adjusts the level of the signal returned from the VL70-m chorus effect stage. The higher the value, the higher the level of the chorus signal.

VarRtn (Variation Return)

Settings: 000 … 127

Adjusts the level of the signal returned from the VL70-m variation effect stage. The higher the value, the higher the level of the variation signal. This parameter is not available (“***” will appear in place of the VarRtn value) when the variation stage is connected as an “insertion” effect (page 86).

Trans (Transpose)

Settings: -24 … 0 … +24

Transposes the pitch of the entire VL70-m system (a single setting applies to all voices) down or up in semitone steps over a ± 2 octave range. “+00” corresponds to standard pitch. Each increment corresponds to a semitone. A setting of “-12”, for example, transposes the pitch down one octave.

The VL-XG PLAY Mode 41