P-2302R Series User’s Guide

Table 35 SUA/NAT Setup

LABEL

DESCRIPTION

 

 

End Port

Type a port number in this field.

 

To forward only one port, type the port number in the Start Port field above and

 

then type it again in this field.

 

To forward a series of ports, type the last port number in a series that begins with

 

the port number in the Start Port field above.

Server IP

Enter the inside IP address of the server here.

Address

 

Apply

Click Apply to save your changes back to the Prestige.

 

 

Reset

Click Reset to begin configuring this screen afresh.

 

 

12.5 Configuring Address Mapping

Ordering your rules is important because the Prestige applies the rules in the order that you specify. When a rule matches the current packet, the Prestige takes the corresponding action and the remaining rules are ignored. If there are any empty rules before your new configured rule, your configured rule will be pushed up by that number of empty rules. For example, if you have already configured rules 1 to 6 in your current set and now you configure rule number 9. In the set summary screen, the new rule will be rule 7, not 9. Now if you delete rule 4, rules 5 to 7 will be pushed up by 1 rule, so old rules 5, 6 and 7 become new rules 4, 5 and 6.

To change your Prestige’s address mapping settings, click SUA/NAT, then the Address Mapping tab. The screen appears as shown.

135

Chapter 12 Network Address Translation (NAT) Screens