P-2302R Series User’s Guide

Table 129 Menu 24.11 – Remote Management Control

FIELD

DESCRIPTION

 

 

Telnet Server

Each of these read-only labels denotes a service or protocol.

FTP Server

 

Web Server

 

SNMP Service

 

DNS Service

 

 

 

Port

This field shows the port number for the service or protocol. You may change the

 

port number if needed, but you must use the same port number to access the

 

Prestige.

Access

Select the access interface (if any) by pressing [SPACE BAR], then [ENTER] to

 

choose from: LAN only, WAN only, ALL or Disable.

Secure Client IP

The default 0.0.0.0 allows any client to use this service or protocol to access the

 

Prestige. Enter an IP address to restrict access to a client with a matching IP

 

address.

Once you have filled in this menu, press [ENTER] at the message "Press ENTER to Confirm or ESC to Cancel" to save your configuration, or press [ESC] to cancel.

Remote management over LAN or WAN will not work when:

1A filter in menu 3.1 (LAN) or in menu 11.5 (WAN) is applied to block a Telnet, FTP or Web service.

2You have disabled that service in menu 24.11.

3The IP address in the Secure Client IP field (menu 24.11) does not match the client IP address. If it does not match, the Prestige will disconnect the session immediately.

4There is already another remote management session with an equal or higher priority running. You may only have one remote management session running at one time.

321

Chapter 35 Remote Management