P-2302R Series User’s Guide

Figure 154 Menu 21.1.x.x: TCP/IP Filter Rule

Menu 21.1.2.3 - TCP/IP Filter Rule

Filter #: 1,1

TCP/IP Filter Rule

Filter Type=

Active= Yes

0

IP

Source Route= No

IP Protocol=

Destination: IP Addr=

 

 

IP Mask=

 

 

Port #=

 

 

Port # Comp= None

Source: IP Addr=

 

 

IP Mask=

 

 

Port #=

 

 

Port # Comp= None

TCP Estab= N/A

Log= None

More= No

 

Action Matched= Check

Next Rule

Action Not Matched= Check Next Rule

Press ENTER to Confirm or ESC to Cancel:

The following table describes how to configure your TCP/IP filter rule.

Table 116 Menu 21.1.x.x: TCP/IP Filter Rule

FIELD

DESCRIPTION

 

 

Active

Press [SPACE BAR] and then [ENTER] to select Yes to activate the filter rule or No

 

to deactivate it.

IP Protocol

Protocol refers to the upper layer protocol, e.g., TCP is 6, UDP is 17 and ICMP is 1.

 

Type a value between 0 and 255. A value of 0 matches ANY protocol.

IP Source Route

Press [SPACE BAR] and then [ENTER] to select Yes to apply the rule to packets

 

with an IP source route option. Otherwise the packets must not have a source route

 

option. The majority of IP packets do not have source route.

Destination

 

 

 

IP Addr

Enter the destination IP Address of the packet you wish to filter. This field is ignored

 

if it is 0.0.0.0.

IP Mask

Enter the IP mask to apply to the Destination: IP Addr.

 

 

Port #

Enter the destination port of the packets that you wish to filter. The range of this field

 

is 0 to 65535. This field is ignored if it is 0.

Port # Comp

Press [SPACE BAR] and then [ENTER] to select the comparison to apply to the

 

destination port in the packet against the value given in Destination: Port #.

 

Options are None, Equal, Not Equal, Less and Greater.

 

 

Source

 

 

 

IP Addr

Enter the source IP Address of the packet you wish to filter. This field is ignored if it

 

is 0.0.0.0.

IP Mask

Enter the IP mask to apply to the Source: IP Addr.

 

 

Chapter 30 Filter Configuration

282