P-2302R Series User’s Guide

Figure 119 Menu 11.3 Remote Node Network Layer Options for Ethernet Encapsulation

Menu 11.3 - Remote Node Network Layer Options

IP Address Assignment= Dynamic

IP Address= N/A

IP Subnet Mask= N/A

Gateway IP Addr= N/A

Network Address Translation= SUA Only

Metric= 1

Private= N/A

RIP Direction= None

Version= N/A

Multicast= None

Enter here to CONFIRM or ESC to CANCEL:

This menu displays the My WAN Addr field for PPPoE encapsulation and Gateway IP Addr field for Ethernet encapsulation. The following table describes the fields in this menu.

Table 106 Remote Node Network Layer Options

FIELD

DESCRIPTION

 

 

IP Address

If your ISP did not assign you an explicit IP address, press [SPACE BAR] and then

Assignment

[ENTER] to select Dynamic; otherwise select Static and enter the IP address &

 

subnet mask in the following fields.

(Rem) IP

If you have a static IP Assignment, enter the IP address assigned to you by your ISP.

Address

 

(Rem) IP

If you have a static IP Assignment, enter the subnet mask assigned to you.

Subnet Mask

 

Gateway IP

This field is applicable to Ethernet encapsulation only. Enter the gateway IP address

Addr

assigned to you if you are using a static IP address.

My WAN Addr

This field is applicable to PPPoE encapsulation only. Some implementations,

 

especially the UNIX derivatives, require the WAN link to have a separate IP network

 

number from the LAN and each end must have a unique address within the WAN

 

network number. If this is the case, enter the IP address assigned to the WAN port of

 

your Prestige.

 

Note that this is the address assigned to your local Prestige, not the remote router.

 

 

Network

Network Address Translation (NAT) allows the translation of an Internet protocol

Address

address used within one network (for example a private IP address used in a local

Translation

network) to a different IP address known within another network (for example a public

 

IP address used on the Internet).

 

Choose None to disable NAT.

 

Choose SUA Only if you have a single public IP address. SUA (Single User Account)

 

is a subset of NAT that supports two types of mapping: Many-to-Oneand Server.

 

Choose Full Feature if you have multiple public IP addresses. Full Feature mapping

 

types include: One-to-One,Many-to-One (SUA/PAT), Many-to-Many Overload,

 

Many- One-to-Oneand Server. When you select Full Feature you must configure at

 

least one address mapping set!

 

See for a full discussion on this feature.

 

 

Metric

Enter a number from 1 to 15 to set this route’s priority among the Prestige’s routes.

 

The smaller the number, the higher priority the route has.

251

Chapter 26 Remote Node Configuration