2Put the SMT in command interpreter (CI) mode by entering 8 in Menu 24 – System Maintenance.
3Enter command “sys stdio 0” to disable the SMT timeout, so the TFTP transfer will not be interrupted. Enter command “sys stdio 5” to restore the
4Launch the TFTP client on your computer and connect to the Prestige. Set the transfer mode to binary before starting data transfer.
5Use the TFTP client (see the example below) to transfer files between the Prestige and the computer. The file name for the configuration file is
Note that the telnet connection must be active and the SMT in CI mode before and during the TFTP transfer. For details on TFTP commands (see following example), please consult the documentation of your TFTP client program. For UNIX, use “get” to transfer from the Prestige to the computer and “binary” to set binary transfer mode.
33.2.7 TFTP Command ExampleThe following is an example TFTP command:
tftp
where “i” specifies binary image transfer mode (use this mode when transferring binary files), “host” is the Prestige IP address, “get” transfers the file source on the Prestige
The following table describes some of the fields that you may see in
Table 125 General Commands for
COMMAND | DESCRIPTION |
|
|
Host | Enter the IP address of the Prestige. 192.168.1.1 is the Prestige’s default IP address |
| when shipped. |
Send/Fetch | Use “Send” to upload the file to the Prestige and “Fetch” to back up the file on your |
| computer. |
Local File | Enter the path and name of the firmware file (*.bin extension) or configuration file |
| (*.rom extension) on your computer. |
Remote File | This is the filename on the Prestige. The filename for the firmware is “ras” and for the |
| configuration file, is |
Binary | Transfer the file in binary mode. |
|
|
Abort | Stop transfer of the file. |
|
|
Chapter 33 Firmware and Configuration File Maintenance | 308 |