Husqvarna 128CD, 128LD manual Return springs work properly

SAFETY INSTRUCTIONS

Throttle lock-out

SMake sure the throttle control is locked at the idle setting when the throttle lock-- out is released.

SPress the throttle lock--out and make sure it returns to its original position when you release it.

SCheck that the throttle control and throttle lock--out move freely and that the

return springs work properly.

SSee instructions under the section “Start”. Start the machine and apply full throttle. Release the throttle and check that the cutting attachment stops and re- mains at a standstill. If the cutting attach- ment rotates with the throttle in the idle position then the carburetor idle setting must be checked. See instructions under the section “Maintenance”.

115374327 Rev. 6 5/31/12

Stop switch

SStart the engine and make sure the engine stops when you push and hold the stop switch.

Cutting attachment guard

SEnsure that the guard is undamaged and is not cracked.

SReplace the guard if it has been exposed

to impact or is cracked.

SAlways use the recommended guard for the cutting attachment you are using. See section on “Technical data”.

Muffler

SNever use a machine that has a faulty muffler.

SRegularly check that the muffler is securely attached to the machine.

SThe muffler on this unit is equipped with a special spark arrestor mesh. The mesh should be checked and, if necessary. cleaned by a servicing dealer. A blocked mesh will cause the machine to overheat, which can lead to serious damage. Never use a muffler with a defective spark arres- tor mesh. See the Maintenance section.

English--- 6