Husqvarna 128LD, 128CD manual Spark plug, Two--piece shaft, Air filter, Cleaning the air filter

Page 19

MAINTENANCE

Muffler bolts

Spark arrestor mesh

CAUTION! Never use a machine that has a faulty or loose muffler. Ensure the muffler bolts are tight.

CAUTION: Mufflers fitted with cata- lytic converters get very hot during use and remain so for some time after stop- ping. This also applies at idle speed. Con- tact can result in burns to the skin. Re- member the risk of fire!

WARNING: The inside of the muffler contain chemicals that may be carcinogenic. Avoid contact with these elements in the event of a damaged muffler.

WARNING: Engine exhaust fumes contain carbon monoxide, which can cause carbon monoxide poisoning. DO NOT start or run the machine indoors, or anywhere that is poorly ventilated. The exhaust fumes from the engine are hot and may contain sparks which can start a fire. Never start the machine in- doors or near combustible material!

Spark plug

The spark plug condition is influenced by:

SIncorrect carburetor adjustment.

SAn incorrect fuel mixture (too much or in- correct type of oil).

SA dirty air filter.

These factors cause deposits on the spark plug electrodes, which may result in operat- ing problems and starting difficulties.

If the machine is low on power, difficult to start or runs poorly at idle speed: always check the spark plug first before taking any further action. If the spark plug is dirty, clean it and check that the electrode gap is 0.024″ (0.6 mm). The spark plug should be replaced after about a month in operation or earlier if necessary.

CAUTION! Always use the recommended spark plug type! Use of the wrong spark plug can damage the piston/cylinder.

115374327 Rev. 6 5/31/12

0.024″ (0.6 mm)

Two--piece shaft

The drive shaft end in the lower shaft should be lubricated with grease every 30 hours. There is a risk that the drive shaft ends (splined coupling) will seize if they are not lubricated regularly.

Air filter

The air filter must be regularly cleaned to remove dust and dirt in order to avoid:

SCarburetor malfunctions S Starting problems

S Loss of engine power

S Unnecessary wear to engine parts S Excessive fuel consumption

Clean the filter every 25 hours, or more regularly if conditions are exceptionally dusty.

Cleaning the air filter

Remove the air filter cover and take out the filter. Wash it clean in warm, soapy water. Rinse thoroughly. Ensure that the filter is dry before refitting it.

An air filter that has been in use for a long time cannot be cleaned completely. The filter must therefore be replaced with a new one at regular intervals. A damaged air filter must always be replaced.

English--- 19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Page Contents Symbols KEY to SymbolsRev 5/31/12 Only intended for trimmer heads Personal protective equipment Safety InstructionsMachine’s safety equipment Stop switchTrimmer head is intended for trimming grass Cutting attachment guardMuffler Cutting equipmentReturn springs work properly General rules Trimmer headTrimmer line of the same diameter Personal protection General safety precautionsSafety instructions regarding the surroundings Safety instructions before starting workStarting Fuel safetyBasic safety rules General working instructionsClearing Basic working techniquesCutting Sweeping 128LD 128CD Know Your TrimmerKnow your trimmer Fitting the trimmer guard and trimmer head Model 128LD AssemblyFitting the loop handle Assembling and dismantling the two--piece shaftFitting the trimmer guard and trimmer head Model 128CD Fuel mixture Fuel HandlingFueling Cold engine Starting and StoppingCheck before starting Starting and stoppingStopping Warm engineMuffler MaintenanceUnit/Maintenance Safety CarburetorAir filter Cleaning the air filterSpark plug Two--piece shaftMonthly maintenance Maintenance scheduleDaily maintenance Weekly maintenanceTrimmer Head Line Loading Instructions Technical data Technical DataWarranty Commencement Date Avertissement Utilisés de ContenuContenu Contrôler les points suivants avant la mise en marcheUn nettoyage régulier est indispensable Examen visuel Explication DES SymbolesSymboles Destiné uniquement aux têtes de coupeUtiliser des bottes antidéparapantes et stables Instructions DE SécuritéÉquipement de sécurité de la machine Blocage de l’accélérationAvertissement L’intérieur Avertissement Une exAvertissement Les gaz Instructions DE Sécurité Règles élémentaires Tête de coupeConsignes de sécurité pour l’entourage Avertissement ToujoursInstructions générales de sécurité Protection personnelleSécurité du mise en marche Consignes de sécurité avant la mise en serviceAvertissement Lorsque le Sécurité carburantAvertissement Il arrive que Avertissement ManipulerMéthodes de travail Techniques de travail de baseCoupe Avertissement AttentionBalayage Manuel d’instructions EPA FAMILIARISEZ-VOUS Avec Votre AppareilFamiliarisez-vous avec votre appareil Bouton d’arrêt Huile à 2 tempsAvertissement Tous les MontageMontage de la poignée en boucle Montage et démontage d’un tube de transmission démontableAvertissement Le carbu Manipulation DU CarburantMontage du protecteur et la tête de coupe Modèle 128CD CarburantMin m 10 ft Avertissement Le potRemplissage de carburant Avertissement Les me MélangeMoteur froid Démarrage ET ArrêtContrôles avant la mise en marche Démarrage et arrêt Avertissement Un couvArrêt Moteur chaudEntretien Vis de silencieux Grille pare--étincelles BougieTube de transmission démontable Filtre à airSchéma d’entretien Renvoi d’angle 128LDRemplacement du fil dans la tête de coupe Caractéristiques techniques Caractéristiques TechniquesDroits ET Obligations DE Votre Garantie Accessoires Numéro de la pièceADD-ON or Modified Parts Durée DE Couverture Advertencia Una desbroza ContenidoContenido Antes de arrancar, observe lo siguienteSímbolos Identificacion DE SimbolosAdvertencia Nunca utilice Instrucciones DE SeguridadEquipo de protección personal Advertencia Para trabajar Equipo de seguridad de la máquinaAdvertencia La sobre ex Advertencia Bajo ningunaAdvertencia Los humos de ¡IMPORTANTE Interruptor de paradaReglas básicas Advertencia Pare siempreCabezal de corte Obtener un resultado de corte óptimoInstrucciones de seguridad para el entorno Instrucciones generales de seguridadAdvertencia Un equipo de Protección personalSeguridad de arranque Advertencia Cuando elSeguridad en el uso del com- bustible Advertencia Sea cuidadosoReglas básicas de seguridad Instrucciones generales de trabajoTécnica básicas de trabajo Advertencia a veces, seBarrido CorteConozca su aparato Conozca SU AparatoMontaje de la protector y la cabezal de corte Modelo 128LD MontajeMontaje de mango de tipo cerrado Montaje y desmontaje del tubo divisibleRodeada por el protector de polvo Montaje de la protector y la cabezal de corte Modelo 128CDCarburante Manipulacion DEL CombustibleAdvertencia El combus Repostaje Problemas de funcionamientoMotor frio Arranque Y ParadaControl antes de arrancar Arranque y parada Advertencia Antes de arMotor caliente Seguridad del aparato y su mantenimiento MantenimientoCarburador Advertencia Si no puedeMm 0,024 de pulgada BujíaTubo divisible Filtro de airePrograma de mantenimiento Engranaje angulado 128LDReemplazo de la línea en el cabezal de corte Datos técnicos Datos TecnicosAccesorio del cortadora de ramas, con tubo 952 711 Accessorios Número de piezaFecha DEL Comienza DE LA Garantia
Related manuals
Manual 4 pages 16.46 Kb Manual 7 pages 30.43 Kb Manual 4 pages 15.86 Kb

128CD, 128LD specifications

The Husqvarna 128LD is a versatile, user-friendly outdoor tool designed to make yard work easier and more efficient. Known for its lightweight design and robust performance, this multi-purpose trimmer is part of Husqvarna's extensive lineup of outdoor power equipment, aimed at both homeowners and professional landscapers.

One of the standout features of the 128LD is its powerful 28cc, 2-stroke engine. This engine provides a perfect blend of performance and fuel efficiency, delivering the power needed to tackle tough grass and weeds while minimizing fuel consumption. The smart design also includes an easy-starting system that reduces the effort required to start the machine, ensuring you can get to work without frustration.

The 128LD is not just a trimmer, but a multi-tool system that accommodates various attachments, such as a blower, edger, and cultivator. This versatility makes it an ideal choice for homeowners looking to maintain their gardens and yards with minimal equipment. The detachable shaft allows for easy swapping of attachments, ensuring that you have the right tool for any task.

Equipped with an adjustable handle, the Husqvarna 128LD promotes comfort and efficiency during use. The soft-grip handle minimizes vibration, allowing you to work longer without discomfort. Additionally, the curved shaft design enhances reach and precision, making it easier to trim around flower beds, pathways, and other narrow spaces.

Another critical feature of the 128LD is its dual line cutting system. This system allows for a wide cutting swath, effectively reducing the time spent on yard work. The patented Tap 'n Go trimmer head enables easy line adjustment, letting you extend the cutting line simply by tapping the head on the ground, ensuring you're always ready to work without interruptions.

In terms of durability, the Husqvarna 128LD is built to last. High-quality materials and construction ensure it can withstand the rigors of outdoor use, providing reliable performance over time.

Overall, the Husqvarna 128LD stands out as a powerful and versatile multitool that caters to a broad range of outdoor maintenance needs, making it a valuable addition to any homeowner's gardening arsenal. Whether you're trimming grass, edging pathways, or tackling tougher overgrown areas, the 128LD delivers reliability and ease of use in one efficient package.
Top Page Image Contents