Ruud GEN12AD-V manual Changing Oil Filter, Add oil as described in Checking/Adding Engine Oil

Page 20

4.Remove brass fitting from end of drain hose and drain oil into an approved container.

5.When oil has drained, replace brass fitting on hose.

6.Add oil if not changing oil filter, See Checking/Adding Engine Oil.

Changing Oil Filter

1.Place an approved container under oil filter.

2.Remove oil filter and dispose of properly.

3.Before installing a new oil filter, lightly lubricate the oil filter gasket with fresh, clean oil.

4.Install the oil filter by hand until the gasket contacts the oil filter adapter, then tighten the oil filter ½ to ¾ turn.

5.Add oil as described in Checking/Adding Engine Oil.

6.Remove container from under oil filter and clean up any spilled oil.

7.Start and run engine. As engine warms up, check for oil leaks.

8.Stop engine, wait for oil to settle, check oil level and add if necessary as described in Checking/Adding Engine Oil.

NOTICE Any attempt to crank or start the engine before it has been properly serviced with the recommended oil will result in equipment failure.

DO NOT attempt to crank or start the engine before it has been properly serviced with the recommended oil. This may result in engine failure.

REPRODUCTION

 

failure to follow this

Damage to equipment

ulting fro

instruction will void

 

generator warranty.

gine and

NOT

 

 

 

FOR

 

 

 

20

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Generator Systems Save these original instructions for future reference Where to Find UsNot Reproduction For Reproduction Important Safety Instructions Safety Symbols and MeaningsNot ReprRepro VictimLocation Guidelines to insure for RoductionGeneral Installation For the Installing Dealer/ContractorFor the Home Owner OrientatFuel Factors Flammable and explosive, which couldCause burns, fire or explosion resulting Death, serious injury and/or propertyRepr Ction Generator LocationReproduction Not ForDelivery Inspection Generator is supplied with Not includedROD ControlsGenerator Lifting Holes Provided at each corner for lifting generatorAuto mode System Control PanelSET Exercise Used to set Detection SystemAccess Ports To open access doorTo close access door To remove roof and dividerTo remove exhaust panel To install side panelsREP Reprodu OperationMaintenance Exercise timer. See Setting Exercise TimerFault Detection System Fault CodesUction High Temperature FC7 Transfer Switch Fault FC8Engine Maintenance TionChecking/Adding Engine Oil Changing Engine OilInstruction will void Generator warranty Gine Changing Oil FilterAdd oil as described in Checking/Adding Engine Oil Ulting froService Air Cleaner Service Spark PlugsMaintenance section REP OductionClean Air Cooling System Fuel System Inspection and MaintenancePressure Regulator Maintenance and Inspection Natural Gas/Propane Fuel SystemTest System Operation Simulate a Power Outage Battery Servicing the BatteryCharging the Battery ReprductionWhen Calling for Assistance StorageTroubleshooting Problem Cause CorrectionReprodu Ction Protech Standby GeneratorsGenerator Specifications Engine SpecificationsCommon Service Parts ReprodutionSistema generador Doméstico Not Reproduction For Mantenimiento ControlesUtilización Conserve estas instrucciones Símbolos sobre la seguridad y significadosContacto directo con la víctima SteAdvertencia El arran CasasReprod InstalaciónResponsabilidades del distribuidor/técnico instalador Orientación para el propietarioFactores cuando determinen la carga total del generador Factores relacionados con el combustibleEraturasFORelevadas o en Ubicación del generador Inspección al momento de la entrega El generador doméstico incluye lo siguiente No incluyeControles Generador domésticoOrificios para horquilla elevadora Proporcionado en Cada esquina para levantar el generadorPanel de control del sistema ParaPR Uction Para desmontar los paneles lateralesPara solta Que el techo abra ligeramente Levante el techo del generadorProd For Para desmontar el panel de escapePara instalar los paneles laterales  Permita que el equipo se enfríe antes de tocarloUtilización Funcionamiento automáticoAceite de motor BateríaLas MantenimientoParo del sistema La sección Configuración del temporizador de práctica Restablecimiento del sistema de detección de fallasEl motor no arranca FC4 Baja presión de aceite FC2Mantenimiento del generador Aceite del motor Mantenimiento del motorComprobación/adición de aceite para motor Cambio del filtro de ceite Cambio de aceite del motorRevisión del filtro de aire Revisión de las bujías Comprobación de holgura de las válvulasAjuste de En la sección MantenimientoDel temporizador de ejercicio DuctionCircuito de combustible de gas natural/propano Alimentación eléctrica Cargar la batería Servicio la bateríaSi llama a la fábrica AlmacenamientoResolución de problemas DUC TionGeneradores de reserva domésticos Protech Períodos DE LA GarantíaPartes de Servicio Comu ReprouctionEspecificaciones del generador Groupe électrogène Not Reproduction For Installation CommandesFonctionnement ’Huile moteurSymboles de sécurité et Leur sign Repr UctionDirect avec la victime Les Directives générales concernant l’emplacement afin Conseils au propriétaire ’installationAu détaillant ou à l’entrepreneur procédant Facteurs relatifs au combustible Le débit de gaz naturel dépend du combustible spécifiqueMais la dépréciation typique se situe entre 10 et 20% du Débit du gaz de pétrole liquéfiéEmplacement de la génératrice Rs deVérification de la livraison Articles non fournisCommandes Groupe électrogèneTableau de commande de système Pour fermer une porte d’accès Portes d’accèsPour ouvrir une porte d’accès Pour retirer le panneau d’échappement Pour installer les panneaux latérauxODU CT Fonctionnement Réglage de la minuterie du cycle d’exercice Pour exécuter la procédure de réglage du cycle d’exerciceEntreiten Arrêt du systèmeDéfaillance du commutateur de transfert FC8 Emballement du moteur FC6Basse tension génératrice, FC3 Entretien du générateur Vérification/ajout d’huile à moteur Changement d’huile à moteur Entretien du filtre à airChangement du filtre à huile Le par un nouveauInstallez la bougie d’allumage et serrez-la SolidementInspection et entretien du circuit d’alimentation Système au gaz naturel/propaneMettez l’alimentation électrique de service Source d’alimentation de service, la minuterie deÉléments suivants Cylindre du collecteur d’échappement et que tous lesRechargez la batterie Entretien de la batterieVoir Batterie dans la section Considérations pour Communications avec le Fabricant RemisageDépannage Génératrices résidentielles de secours Protech Étendue DE LA GarantiePièces d’entretien courant ReprodctionCaractéristiques du produit

Generator Systems, GEN12AD-V specifications

The Ruud GEN12AD-V is a cutting-edge generator system designed to provide reliable and efficient power solutions for various applications, from residential to commercial use. With a robust design and advanced technology, the GEN12AD-V stands out in the market for its exceptional performance and functionality.

One of the main features of the Ruud GEN12AD-V is its powerful engine. Equipped with a high-performance, air-cooled, four-stroke engine, the generator ensures a steady output of 12,000 watts, making it suitable for running multiple appliances simultaneously, including air conditioning units, refrigerators, and power tools. The engine is designed for fuel efficiency, allowing longer operation times between refueling, which is a significant advantage during extended power outages.

Another notable aspect of the GEN12AD-V is its advanced inverter technology. This allows the generator to produce clean and stable power, minimizing harmonic distortion, which is crucial for sensitive electronics. The pure sine wave output ensures that devices such as laptops, gaming consoles, and medical equipment operate safely and efficiently.

The generator is also equipped with an intelligent monitoring system that provides real-time data on fuel levels, load capacity, and operational hours. This technology helps users manage their energy consumption effectively, ensuring that the generator is always operating within optimal parameters. Additionally, the unit features a user-friendly digital display that provides easy access to all vital information at a glance.

Durability is a hallmark of the Ruud GEN12AD-V, as it is built with a rugged steel frame designed to withstand harsh environmental conditions. The generator's housing is weather-resistant, ensuring protection from rain and debris, making it ideal for outdoor use. The system also incorporates advanced cooling mechanisms to prevent overheating, thereby extending its lifespan.

Safety features are a priority in the design of the GEN12AD-V. It includes automatic shut-off mechanisms that activate in the event of low oil pressure or overheating, protecting both the generator and connected devices. Furthermore, the generator is compliant with various safety standards, ensuring peace of mind for users.

The Ruud GEN12AD-V generator is an outstanding choice for those seeking a reliable, efficient, and durable power solution. Its blend of performance, technology, and safety features positions it as a leading option in the generator market, catering to the needs of both residential and commercial users. Whether for emergency backup power or recreational use, the GEN12AD-V delivers consistent performance and reliability.
Top Page Image Contents