Extron electronic 305SA manual Finish installing the Pole Mount Kit

• Lan 1 - TCP/IP Ethernet

• Lan 2 - MLC controller

• Lan 3 - RGB D IP Plus RJ-45pass-through

• Lan 4 - RGB D IP Plus RJ-45pass-throughM Power supply. Do not apply power yet.

3. — Finish installing the Pole Mount Kit

CAUTION: The PoleVault signal transmission method is specific for PVS 305SA IP switchers working with PVT wallplates. DO NOT connect the input ports to an MTP system or to an LAN or data transmission system.

Connect the cables as follows to the switcher:

A RGB D IP Plus Input wall plate (CAT 5) cables according to the cable labels

B RGB CV D Input wall plate (CAT 5) cables according to the cable labels

NOTE: The default input signal for the switcher ports 3 and 4 is video. Do not connect an RGB cable

(cable A) to ports 3A and 4A when connecting composite video cables to ports 3B and 4B. If using

VGA inputs for ports 3 or 4, the ports must be reconfigured using the MLS Configuration software utility

on the supplied DVD or at www.extron.com.

C Aux audio input 5 cable	I VoiceLift Receiver cable (optional)
D VGA output cable	J Paging sensor cable (optional)
E RCA output cable	K Vol/Mute control.
F Amp audio output to speakers	L Pass-through LAN cables as follows:

G Line out cable to an assistive or recording device (optional, see audio warning card for details)

H Control/power cable from MLC 104 IP Plus

Your completed connections should look like the image below.

AUDIO

IN OUT

COMPUTER IN

MONITOR OUT

SG IR OUT

1BRGB 1ARGB

CAT5e		LAN pass-through
	LAN	cables with RJ-45 connectors to
CAT5e	LAN	4-port Ethernet switch
		inputs 3 and 4 (see 12 )

PVT RGB D IP Plus

Video/audio Inputs

(2 CAT 5 cables, A and B with RJ-45 connectors)

Line Out Output (audio)

Speaker	PVS terminal
wire color	(left and right)
Red	Positive (+)
Black	Negative (-)

Audio Output	4-port 10/100
to Speakers	Ethernet Switch
	Connect to ports as follows:
	1.	TCP/IP network
	2.	MLC controller
	3.	PVT RGB D IP Plus RJ-45 pass-through
	4.	PVT RGB D IP Plus RJ-45 pass-through

1

7 6 12

N15779

I

POWER N P

U

T

S

12V

5A MAX

13

1A RGB 2A RGB 3A RGB 4A RGB

1B RGB	2B RGB	3B RGB	4B RGB
		/VIDEO	/VIDEO

2

	OUTPUTS	VOICELIFT
	VIDEO
RGB		RECEIVER

4 5 9

	LINE OUT	AMPLIFIED AUDIO OUT
		DO NOT
		GROUND
		OR SHORT				2/4/8
		SPEAKER				Ohms
L	R	OUTPUTS
		CLASS 2 WIRING		L	R
L	R	10V	50mA		CONTROL
					Tx Rx IR	12V

AUX AUDIO	PAGING		RS-232 MLC/IR
INPUT 5	SENSOR	VOL/MUTE

3 10 11 8

LAN 3 LAN 4

LAN 1 LAN 2

PVT CV D Input
(CAT 5 cable with	VIDEO
RJ-45 connector)
Power	3B
Connector
	VIDEO IN
	AUDIO IN
L	R
	S G
	IR OUT
External Power Supply
(12 VDC, 5 A max.)

VGA	VoiceLift	Paging
Connector	Receiver	Sensor
	RCA	10V
	Connector	Vol/Mute
RGB Output		Aux Audio Control
to Projector		Input 5

Composite Video Output to Projector

MLC 104 IP Plus RS-232 input

	MLC		To PVS terminal
	wire color
	White		A - (Tx on RS-232 port)
	Violet		B - (Rx on RS-232 port)
	Drain wire		D - Ground (	)
	Black		D - Ground (	)
	Red		E - +12 V
+12 VDC
Ground (		)
Ground (		)

Receive (Rx) B

Transmit (Tx) A

36PoleVault IP Systems • Installation — Stage 4 (PMK 550 and PVS 305SA IP)