Extron electronic 305SA manual Install Wall Plates

3. — Install Wall Plates

a. Connect the CAT 5 cables to the rear of the

input devices (for RGB devices, connect cable

labeled A to port A and cable B to port B). For

PVT CV D plates connect the single cable to the

device.

b. Run LAN cables (included) to the rear of the

PVT RGB D IP Plus, and connect to the RJ-45

pass-through connectors on the rear panel.

c. With PVT RGB D IP Plus plates, for podcasting

or recording applications, use a three conductor

audio cable and connect the audio return to

the connector marked G (ground wire), R (black

wire), and L (red wire). The other end will be

connected to the Line Out connection on the

PVS 305SA IP switcher.

d. If desired wire the IR connection using a

two conductor cable. Wire the ground to G

and signal lead to S. The other end will be

connected to the IR Out port of the

ÑConnect the cables to the AV source input devices at each location.

Wall

Mud Ring

LAN cables

MLC 104 IP Plus controller.

TIP: Before completing the installation of the

PVT RGB D IP Plus wallplate, see EDID

MInder on page 42 for setup and

operating details.

AUDIOOUT

IN

IN COMPUTER

OUT MONITOR

G

S

IR OUT

Extron®

PVT RGB D IP Plus

CAT5e

CAT5e

e.	Mount each device into the mud ring, using the
	supplied screws.
f.	Attach the supplied Decora® faceplate.
g.	Label the Decora plate with the supplied label,
	using the appropriate input number. This makes
	inputs easier to identify when configuring the
	switcher.
h.	Repeat steps a through g for other wall plates.

CAT 5 cables

from PoleVault® Switcher

Decora®

Faceplate

AUDIO

IN OUT

CAT5e

COMPUTER IN

MONITOR OUT

S G CAT5e

IR OUT

®Mount the PVT in the mud ring then ©attach the Decora faceplate.

PoleVault IP Systems • Installation — Stage 2 (Wallplates and MLC) 25