Extron electronic 305SA manual PVT CV D and PVT RGB D IP Plus AV Source Input Wallplates

Stage 2:

Mounting the PVT

Wallplates and the

MediaLink Controller

Stage 2 Involves Installing and Cabling the Devices Shown Below.

NOTE: The installation must conform to national and local electrical codes and UL requirements. See the

device user guide for details.

PVT CV D and PVT RGB D IP Plus AV Source Input Wallplates

PVT CV D PVT RGB D IP Plus

			FRONT	REAR
				Line Out Audio
				Output Port
	Audio and		VIDEO IN	Audio and
				Video input
	Video input
			AUDIO IN	Connectors
	Connectors
		L	R
			IR OUT
			S G	Local Monitor
	IR Output
				Output Port
				IR Output
Decora	Mounting	Audio and Video		IR Input

AUDIO

IN OUT

COMPUTER IN

MONITOR OUT

S G

IR OUT

FRONT

EDID Learn

Button

EDID Learn

Status LED

CAT5e

CAT5e

RJ-45 LAN

Pass-through

Input

Connectors

Faceplate	Screws (2)	Output Port (at rear)	Connector
			(at rear)

REAR

5-pole EDID DIP switch (at rear)

• Where it goes: Installs in a wall near input source location.					Line Out
• What it does: Transmits an input source’s composite or RGB				L	Audio
video signal and audio signals to the switcher.	CAT5e				Connector
		1 2 3	ON	G R	(at rear)
In addition the PVT RGB D IP Plus allows pass-through Ethernet		4		G
connection.		5
		RGB A		RGB B
				S	IR Input
	CAT5e	OUT		OUT
NOTES:					Connector
					(at rear)
• The PVT CV D is a 1-gang wallplate.
• The PVT RGB D IP Plus is a 2-gang wallplate.	RJ-45 LAN Pass-through			Audio and Video
• Both the PVT RGB D IP Plus and the optional	Connectors (2 at rear)			Output Ports (2** at rear)
	** Each RGB Wallplate needs
PVT RGB D (EDID) incorporate EDID Minder. This allows
	2 Output Cables, A and B.
the transmitter to communicate the appropriate EDID
information to the source, ensuring correct video output
resolution.
Before fully installing the PVT RGB D IP Plus wallplate,
see EDID MInder on page 42 for setup and operating
details.

PoleVault IP Systems • Installation — Stage 2 (Wallplates and MLC) 21