DS62-Network, DS62-MD4 Network/Modem Host Module
Delete ALL outlet groups? (Y/N): y
Note: There will be no confirmation the groups have been deleted. Select option 1 from the Outlet Group Configuration to verify all outlet groups were deleted.
# Group Name | Outlets |
Strike ENTER to continue
Firmware / Config Download
This option allows the admin to flash upgrade the firmware to the Host module through an FTP client. The admin can upload the configuration file, make changes, and download back to the unit. This feature ensures multiple units will have the same configuration without having to manually configure each unit separately.
Enable Firmware Upgrade | 1 |
Enable SSL Cert Upload | 2 |
Enable Configuration File Upload..3 | |
Restore Configuration Defaults.... | 4 |
Get Current Configuration File.... | 5 |
Display Configuration Error Log... | 6 |
Exit | X,CR |
Enter Request : |
|
NOTE: Contact Baytech Support for the instruction sheet and firmware upgrade file.
Enable Firmware Upgrade
This option must be enabled to upgrade the firmware via FTP. The DS unit will display the following, Default is Disabled:
Enabling this will allow the firmware to be updated via ftp
Enable Firmware Upgrade ? (Y/N)
IMPORTANT: Do not type ‘Y’ unless you have received the instructions and firmware from Baytech’s Technical Support. If you typed ’Y’ and see the following below, turn power off than back on to the unit to close the firmware upgrade.
Waiting to receive compressed image file
At this point follow the instruction to FTP the firmware into the unit.
39