Bay Technical Associates DS62-MD4, DS Series manual IP Address, Subnet Mask

DS62-Network, DS62-MD4 Network/Modem Host Module

Network setup :	00:C0:48:00:01:FD
Ethernet Address
IP Address		70.150.140.89
Subnet Mask		255.255.255.224
Default Gateway		70.150.140.65
Connection Inactivity Timeout (mins): Disabled
Carriage Return Translation: Enabled
Break Length (msecs): 350		SSH is Enabled
DHCP is Disabled Telnet is Enabled
SSH host keys are set to factory default
IP Address	1
Subnet Mask	2
Gateway Address	3
Inactivity Timeout	4
Carriage Return Translation	5
Break Length	6
DHCP Enable/Disable	7
Telnet Enable/Disable	8
SSH Enable/Disable	9
SSH Host Key Generation	10
IP Filter Configuration	11
SNMP Configuration	12
Web Server Configuration	13
Exit	X,CR

IMPORTANT: For network access, you must configure the IP addresses, Subnet Mask, and Gateway Address. The module must be reset for network changes to take effect.

IP Address

The IP address is the network address assigned by your network manager for your network. The IP Address consists of four bytes, each byte ranging from 0 to 255. This parameter must be programmed before the DS is accessible via the network.

Select 1) to enter the IP Address. Failure to enter the address in the decimal form causes the DS to display the following until it is entered correctly. Default Module IP Address is 0.0.0.0.

Enter IP address in dotted decimal form :

NOTE: There should be no active connections while configuring the DS module. The unit should be reset upon completion of configuration.

Subnet Mask

The Subnet Mask is a bit mask that identifies the network portion of the IP address, allowing the DS to determine whether to send a packet directly to the client or to a gateway. The Subnet Mask consists of four bytes, each byte ranging from 0 to 255. This parameter must be programmed before the DS- Series can be accessed through the network.

28