3. Switch “ON” the flash unit, and press the camera’s shutter button halfway.
■Now, aperture value and film speed are automatically transmitted to the slave flash unit.
4. Remove the slave flash unit from camera.
5. Press the MODE button and select the / . (Slave Mode)
6. Press the SEL button to make the channel display indicator blink.
7. Press the + button or – button to set the channel number. (C1 or C2)
8. Press the SEL button to make the output amount () display indicator of flash blink.
9. Press the + button or – button to set the flash output amount.
■Set the flash power by setting the distance indicator on the LCD panel to coincide as closely as possible with the actual distance from the slave flash to the subject. If the actual distance is out of range, you need to change the aperture value.
10.Press the SEL button several times to make the display stop blinking.
11.Place the slave unit in the desired location. Do not place the slave unit within the picture area.
Setting for Slave Controller unit
12.Attach the Slave Controller flash unit to the camera body.
13.Press the MODE button and select the / (Slave Mode).
14.Press the SEL button to make the channel display indicator blink.
15.Press the + button or – button to set the same channel number as that set on the firing flash unit.
16.Press the SEL button to make the flash output amount () display indicator blink.
17.Press the SEL button to make the display stop blinking. (mark disappear and, channel display will appear)
18.After you confirm that all flash units are fully charged, press the shutter button to take the picture.
■When the firing flash unit of
■You cannot set the aperture value by SEL button, if you select the mark at the setting of flash output amount. The flash unit will be set to the Slave Controller mode.
■The Slave Controller unit functions only to control the slave unit.
SPECIFICATIONS
TYPE :
GUIDE NUMBER : 50 (ISO 100/m, 105mm head position)
POWER SOURCE : Four AA type alkaline batteries or, : Four AA type
:Four AA type
:about 4.0 sec.
:about 100 flashes
FLASH ILLUMINATE ANGLE : 28mm - 105mm motor powered control (17mm with
AUTO POWER OFF : Available
COLOR TEMPERATURE : Suitable for Daylight type Color Films
WEIGHT : 335 g / 11.8oz.
DIMENSIONS : 77mm(W)/3.0in. x 139mm(H)/5.5in. x 117mm(L)/4.6in.
25