Points worth knowing, Safety instructions

Points worth knowing

The mecablitz 60 CT-1 is supplied complete with 60-38 battery and charger.

Outstanding features:

•Universal, swivelling quadrolight reflector for bounced flash without having to forgo the benefits of automatic exposure control.

•Wide-angle diffuser.

•Automatic exposure control with a selection of 6 working apertures to easi- ly resolve the problems associated with depth-of-field and to offer greater creative scope regarding camera settings.

•Power-saving thyristor light output control, particularly in the close-up ran- ge, for shorter recycle times and a higher number of flashes from just one battery charge

•Correct exposure confirmation (auto check) with a long display duration.

•Convenient calculator dial for all settings.

•Manual mode or operation with partial light ouput.

• Operation with winder cameras.

1. Safety instructions

•The flash unit is exclusively intended and approved for photographic use!

•Never fire a flash in the vicinity of flammable gases or liquids (petrol, solvents, etc.) - DANGER OF EXPLOSION!

•Never take flash shots of car, bus or train drivers, or of motorcycle and bicycle riders, whilst they are travelling. They could be blinded by the light and cause an accident!

•Never fire a flash in the immediate vicinity of the eyes! Flash fired direct- ly in front of the eyes of a person or animal can damage the retina and lead to severe visual disorders - even blindness!

•Only use the approved power sources listed in the Operating Instructions!

•Do not expose batteries to excessive heat, sunshine, fire and the like!

•Never throw exhausted batteries on to a fire!

•Exhausted batteries should be immediately removed from the flash unit! Lye leaking out of spent batteries will damage the unit.

•Never recharge dry-cell batteries!

•Do not expose the flash unit or battery charger to dripping or splashing water!

•Protect the flash unit from excessive heat and humidity! Do not store the flash unit in the glove compartment of a car!

•Never place material that is impervious to light in front of, or directly on, the reflector screen. The reflector screen must be perfectly clean when a flash is fired. The high energy of the flash light will burn the material or damage the reflector screen if this is not observed.

•Do not touch the reflector screen after a series of flash shots. Danger of burns!

•Never disassemble the flashgun! DANGER: HIGH VOLTAGE!

•There are no components inside the flashgun that can be repaired by a layperson.