B&K 8510 instruction manual Immediate Action Keys, Front Panel Menus, Key Pad, Tran

Immediate Action Keys

V-set			Choosing CV mode and setting the input of regulation voltage mode
I-set			Choosing CI mode and setting the input of regulation current mode
P-set			Choosing CP mode and setting the input of regulation power mode
R-set			Choosing CR mode and setting the input of regulation resistor mode
Shift	+	A	Switch to A setting value
Shift	+	B	Switch to B setting value
Shift	+	Store	Press to store an existing electronic load state in non-volatile Memory.
Shift	+ Recall		Press to recall an existing electronic load state in non-volatile Memory.
Shift	+	Menu	Enter operation Menu.
Shift	+	Short	Turn on or turn off short circuit Test.
Shift	+	Tran	Start /Stop transition operation
Shift	+ Trigger		Causes a trigger to occur. Change the trigger source is IMMIDIATE
Shift	+ Battery		Battery discharge electronic operation
Shift	+ S-Tran		Set the transition operation parameter
On/Off			Enable or disable load input.

Front Panel Menus

POWER

1	2	3	ESC
A	B	Tran
4	5	6	0

Store Recall S-Tran Menu

7 8 9

Local Battery Short Trigger

I-set V-set

P-set R-set

Shift Input on/off

ENTER

Key Pad

0 ～ 9	0 through 9 are used for entering numeric values.
	Decimal point.
ESC	The escape key. It may used to exit any working state.
I-set	Choosing CC mode and setup the input current of regulation current mode.
V-set	Choosing CV mode and setup the input voltage of regulation voltage mode.
P-set	Choosing CW mode and setup the input watt of regulation power mode.
R-set	Choosing CR mode and setup the input resistor of regulation resistance mode.
Shift	Shift keys.
On/Off	Power ON/OFF
	8