Lincoln Electric IM584-D manual 8INSTALLATIONA-8

A-8INSTALLATIONA-8

S2 DIP Switch Bank on Control Box Motherboard (For software version S24004-3 & up)

Switch	Off		On
1	Network Group ID, MSB	(Assigns Control Box to a specific group) (Off is factory setting)
2	Network Group ID, LSB	(Assigns Control Box to a specific group ) (Off is factory setting)
3	Spare
4	Spare
5	Spare
6	Must be off for normal operation		Adjust lower limits
7	Must be off for normal operation		Adjust upper limits
8	Must be on for European units only

S1 DIP Switch Bank on Control Box Motherboard (For software version S24004-2 only)

	Switch	Off	On
1		US 4-Step Trigger Logic	Euro 4-Step Trigger Logic
2		WFS Display = inches/minute	WFS Display = meters/minute
3		Left Display is always preset WFS	Left Display is preset WFS when weld current is not flowing
			Left Display is actual weld current when weld current is flowing
		CC modes override this switch regardless of position. Left Display is always preset weld cur-
		rent when weld current is not flowing and actual weld current when weld current is flowing
4		Run-in = Minimum Speed Available	Run-in = weld WFS
		If any option containing a Run-in setting is connected to the motherboard, it automatically
		overrides this switch regardless of position.

5

Spare

6

Acceleration, MSB (Sets acceleration rate for wire drive) see below

7

Acceleration (Sets acceleration rate for wire drive) see below

8

Acceleration, LSB (Sets acceleration rate for wire drive) see below

Note: the factory shipped settings for all of the S1 and S2 switches is “OFF”.

MSB - Most Significant Bit or Byte. This is the bit in a binary number or DIP switch bank that is furthest to the left. LSB - Least Significant Bit or Byte. This is the bit in a binary number or DIP switch bank that is furthest to the right.

POWER FEED 10