ACCESSORIES | ||
|
|
|
K590-5 WATER CONNECTION KIT (FOR DRIVE ONLY)
Install per the instructions shipped with the kit.
K1536-1 WATER FLOW SENSOR KIT
Install per the instructions shipped with the kit
K659-1 GAS GUARD REGULATOR
Adjustable flow regulator with removable adjuster key for CO2 and Argon blend gases. Mounts onto feeder inlet, and reduces gas waste and arc start “blow” by reducing surge caused by excess pressure in supply hose.
Install the
K1557-1 SWIVEL MOUNT
The
K1556-1 LIGHT DUTY CASTER KIT
This option provides 4 casters and all required hard- ware to mount it to the Power Feed 10. This option is compatible with the
K1574-1 SECURITY DOOR (LARGE)
1.Turn off power.
2.Unlatch and swing open the small door. Remove the two screws from the horizontal hinge rod. Save the screws.
3.While holding the door so it doesnʼt fall, Slide the rod out sideways releasing the door.
4.Position the new door between the panel holes and
5.Replace the two screws and tighten.
6.Swing the door into the up position. A lock may be installed through the side holes for security purposes.
K1555-1 INSULATED LIFT HOOK
For applications where an insulated lift hook is required. This kit provides an easily installed, heavy duty insulated lift eye that mounts to the wire reel stand mast. See the instructions provided with the kit for installation.
K1551-2 INCOMING BUSHING
(4 Ball Roller) (Standard on codes 10600 and up)
This ball bearing equipped incoming bushing can be used in place of the standard incoming wire bushing, when feeding solid steel or cored wire electrodes. It significantly reduces any abrasion to the electrode wire where it enters the feed head. This results in even smoother, more trouble free operation.
POWER FEED 10