This angle should be maintained during the entire cutoff operation.
5.Cut the work piece, exerting only light pressure on the cutoff wheel. Note the direction of the flying sparks!
5.Care and Maintenance
ADanger!
Always disconnect tool from air sup- ply before servicing.
Repair and maintenance work other than described in this section must only be carried out by qualified spe- cialists.
•Check all screwed connections for tightness, tighten if necessary.
•If the tool is not lubricated by a serv- ice unit or line oiler, add for every 15 operating minutes (continuous oper-
ation)
•Do not store tool unprotected out- doors or in damp environment.
6. Available Accessories
•Pneumatic oil 0.5 litre
Special lubricant for air tools, serv- ice units and line oilers.
•
•
For fitting directly to air tools. Improves tool manoeuverability.
ENGLISH
7. Repairs
ADanger!
Repairs to air tools must be carried out by qualified specialists only!
Air tools in need of repair can be sent to the service centre in your country. See spare parts list for address.
Please attach a description of the fault to the air tool.
8. Environmental Protection
The tool's packaging can be 100 % recy- cled.
Worn out machines and accessories contain considerable amounts of valua- ble raw and plastic materials, which can be recycled.
These instructions are printed on paper produced with elemental chlorine free bleaching process.
9. Technical Specifications
Model |
| WS 7400 |
|
|
|
Air consumption | l/min | 400 |
|
|
|
Max. permissible working pressure | bar | 6.3 |
|
|
|
Speed | 11000 | |
Orbital stroke | mm | 5 |
|
|
|
Sanding pad diameter | mm | 125 |
| " | 5 |
|
|
|
Spindle thread |
| M14 |
|
|
|
Vibration (effective value of weighted acceleration) | m/s2 | 0.6 |
Sound power level LWA | dB (A) | 90 |
Sound pressure level LPA | dB (A) | 78 |
Dimensions: |
|
|
length x width x height | mm | 230 x 108 x 148 |
|
|
|
Weight: Tool without packaging | kg | 1.8 |
Tool with packaging | kg | 2.74 |
|
|
|
11