HP 640n Print Server Restore Defaults, Security Level Description Enhanced Security, Recommended

Table 4-15Wizard Security Levels (continued)

Security Level	Description
Enhanced Security	Adds to Basic Security by automatically disabling management protocols that do not use
(Recommended)	secure, encrypted communications (such as Telnet and FTP firmware updates, RCFG,
	SNMP v1/v2c). To change individual protocol settings, see Mgmt. Protocols
	on page 98.
	Use the Admin. Account page to enter the administrator password.
	NOTE: To clear the administrator password, apply blank entries using Custom
	Security, or see Admin. Account on page 93.
	Use the SNMP Configuration pages to configure specific SNMP settings:
	● Enable SNMPv3 (Full-featured print servers only) Enable SNMP v3 and create an
	SNMP v3 account. Not recommended if you manage devices using HP Web
	Jetadmin. See SNMP on page 83.
	● Enable SNMPv1/v2 read-only access Support current tools that rely on SNMP
	v1/v2 for device discovery and status.
	The Configuration Review page displays all the current settings that affect security.
	Click Finish to set your security selections.
Custom Security	Manually set all available security settings supported by your print server. For more
	information on specific parameters and selections, see Mgmt. Protocols on page 98
	and Authorization on page 93.
	Use the Admin. Account page to enter the administrator password.
	NOTE: To clear the Administrator Password, enter blank entries, or see Admin.
	Account on page 93.
	Use the Web Mgmt. page for HTTPS configuration, including certificates and encryption
	levels.
	Use the Management Tools page to configure management protocols that are not
	secure (such as RCFG, Telnet and FTP firmware updates).
	Use the SNMP Configuration pages to configure the following SNMP settings:
	● Enable SNMPv1/v2 Allow management software that uses SNMP v1/v2. If
	selected the SNMPv1/v2 Configuration page is displayed to configure SNMP
	community names.
	● Enable SNMPv3 (Full-featured print servers only) Create an SNMP v3 account. Do
	not create an SNMP v3 account if you manage devices using HP Web Jetadmin.
	See SNMP on page 83.
	Use the Access Control page to control host access to the device. Available on
	selected full-featured print servers only.
	Use the Print Protocols and Services page to enable or disable network printing, print
	services, and device discovery protocols that can affect security.
	Use the Configuration Review page to display all the current settings that affect
	security. Click Finish to set your security selections.

Restore Defaults

Restore the listed configuration parameters to factory default values. The parameters displayed depend on the features supported by the print server.

92 Chapter 4 HP Embedded Web Server (V.45.xx.nn.xx) ENWW