Table 3-2 TFTP configuration file parameters (continued)
ssl-state: (or ssl-redirect-config)
Print server's security level for Web communication, using the following values:
1: Forced redirection to the HTTPS port. Use only HTTPS (secure HTTP) communication.
2: Disable redirection to HTTPS. Use both HTTP and HTTPS communication.
security-reset:
Reset security settings on the print server to factory default values. 0 (default): Do not reset. 1: Reset.
TCP/IP Main
llmnr:
Link local multicast name resolution (LLMNR). 0: Disable. 1 (default): Enable.
host-name: (or sys-name:, name:)
Node name that appears on the HP Jetdirect configuration page. Default is NPIxxxxxx, where xxxxxx represents the last six digits of the LAN hardware address.
ip-config:
Print server configuration method. Use the following values:
◦manual: Wait for IP parameters using manual tools, such as Telnet, the HP Embedded Web Server, the control panel, or installation/management software. Status is User Specified.
◦bootp: Send BOOTP requests on the network for dynamic IP configuration.
◦dhcp: Send DHCP requests on the network for dynamic IP configuration.
◦auto_ip: Automatically configure with a unique
ipsec-config:
The
NOTE: Disable IPsec or Firewall operation on the print server after IPsec/Firewall policies are configured and enabled. You cannot enable IPsec/Firewall operation using this command. Instead, use the HP Embedded Web Server to configure and enable IPsec/Firewall polices.
ip:
IP address for the print server. For example:
ip-config manual
ip 192.168.45.39
In the example, manual signifies manual configuration and ip sets the IP address on the print server. To clear the IP address, set the value to 0.0.0.0. If you change this IP address, you must use it on the next Telnet connection.
ENWW | IPv4 configuration 27 |