HP 640n Print Server manual 3Wireless Station configuration parameters

Table 4-3Wireless Station configuration parameters

Item	Description
Wireless Mode	Select from 802.11b/g (the default) or 802.11b/g/n.
Guard Interval	Select whether to automatically set the guard interval (Auto), or to use a Long (800 ns)
	or Short (400 ns) interval. Guard interval is the space between transmitted symbols
	(characters). Can eliminate inter-symbol interference (ISI), which occurs when echoes or
	reflections from one symbol interfere with another. A long interval can reduce echoes,
	but decrease the data rate. A short interval can increase the data rate by approximately
	10 percent.
	NOTE: This parameter only displays when Wireless Mode is set to 802.11b/g/n.
Enable AMSDU Aggregation	Select whether to enable aggregation of MAC service data units. Aggregating 802.11
	MAC service data units packs them into frames to reduce overhead and increase the
	data rate. Enabling aggregation allows a maximum frame size of 7935 bytes.
	NOTE: This parameter is only displayed when the 802.11b/g/n Wireless Mode is
	selected.
Enable AMPDU Aggregation	Aggregating 802.11 MAC protocol data units packs them into frames to reduce
	overhead and increase the data rate. Enabling aggregation allows a maximum frame
	size of 64k bytes.
	NOTE: This parameter is only displayed when the 802.11b/g/n Wireless Mode is
	selected.
Enable Block ACKs	Select whether to enable acknowledgment of multiple AMPDUs, which allows each of
	the aggregated data frames to be individually acknowledged or retransmitted if affected
	by an error.
	NOTE: This parameter is only displayed when the 802.11b/g/n Wireless Mode is
	selected.
	This parameter is automatically selected when Enable AMPDU Aggregation is
	selected.
Wireless Wizard	Launch the wireless configuration wizard, which guides you through the required 802.11
	wireless configuration parameters and, depending on your choices, bypasses
	unnecessary parameters. Because the individual Wireless configuration parameters are
	documented in this table, the Wireless Wizard is not discussed.
	NOTE: If you improperly exit the wizard, for example by failing to use the Cancel
	button, an Operation Failed screen might appear. If so, wait approximately two minutes
	before restarting the wizard.
Wireless Radio	Click the Enable Wireless Radio button to enable the wireless radio. Click the Disable
	Wireless Radio button to disable it.
	NOTE: The HP Jetdirect print server cannot operate in wireless mode when the radio
	is disabled.

ENWW Networking tab 69