HP 640n Print Server Roam-threshold, Wireless Diagnostics, 00a0f8387af7, Host-name, Specified

Table 3-3Telnet Commands and Parameters (continued)

roam-threshold	Specify the wireless signal strength level where the print server seeks an access point
	that provides a stronger signal strength. Select from the following levels:
	2 (Default): Sets the threshold to a weak signal.
	1: Sets the threshold to a very weak signal.
	0: Sets the threshold to where there is no detected signal.
	When the print server is associated with a particular access point, it remains with that
	access point until the specified threshold level is reached. Setting the threshold level to
	0 or 1 can prevent or limit the print server from roaming.
802.11 Wireless Diagnostics
Current SSID	(Read-only parameter) The network name (SSID) to which the wireless print server is
	connected.
Current Channel	(Read-only parameter) The channel that the wireless print server is currently using.
Signal Strength	(Read-only parameter) Strength of the radio signal received by the print server.
	<blank>: No radio signal detected while the print server is scanning.
	No Signal: No radio signal detected on any channel.
	Poor/Marginal/Good/Excellent: Detected signal strength level.
Access Point Mac	(Read-only parameter) The media access control (MAC) address of the access point
	used for Infrastructure mode communications, as in the following example:
	00:a0:f8:38:7a:f7
	In this example, the access point with MAC address 00a0f8387af7 is used for
	communicating on the network.
TCP/IP Main
llmnr	Link local multicast name resolution (LLMNR).
	0: Disable.
	1 (defualt): Enable.
host-name	Name of the network device. Enter up to 32 alphanumeric characters.
	For example, host-name printer1 assigns the name printer1 to the device. The
	default host name is NPIxxxxxx, where xxxxxx are the last six digits of the LAN
	hardware (MAC) address.
ip-config	Print server configuration method. Use the following values:
	manual: Wait for IP parameters using manual tools, such as Telnet, the HP Embedded
	Web Server, the control panel, or installation/management software. Status is User
	Specified.
	bootp: Send BOOTP requests on the network for dynamic IP configuration.
	dhcp: Send DHCP requests on the network for dynamic IP configuration.
	auto_ip: Automatically configure with a unique link-local address 169.254.x.x.

46 Chapter 3 TCP/IP configuration ENWW