HP 640n Print Server manual Link Speed, Print Protocols

Table C-1HP Jetdirect EIO Menu on Graphical Control Panel (continued)

Menu item	Sub-menu item	Sub-menu item	Values and Description
Link Speed			Set the print server's link speed. The available
			settings depend on the device and installed print
			server. Select one of the following modes:
			Auto (default): Use auto-negotiation to configure the
			highest link speed and communication mode allowed.
			If auto-negotiation fails, either 100TX HALF or 10TX
			HALF is set depending on the detected link speed of
			the hub/switch port. (A 1000T half-duplex selection is
			not supported.)
			10T Half: 10 Mbps, half-duplex operation.
			10T Full: 10 Mbps, full-duplex operation.
			100TX Half: 100 Mbps, half-duplex operation.
			100TX Full: 100 Mbps, full-duplex operation.
			100TX Auto: Limits auto-negotiation to a maximum
			link speed of 100 Mbps on 1000T networks.
			1000TX Full: 1000 Mbps, full-duplex operation.
			CAUTION: Changing the link setting can cause the
			loss of network communication with the print server.
Print Protocols			Print a page that lists the configuration of the following
			protocols: IPX/SPX, Novell NetWare, AppleTalk, DLC/
			LLC.

188 Appendix C HP Jetdirect control panel menus (V.45.xx.nn.xx) ENWW