HP 640n Print Server Ipsec-config Firewall-config, Tftp Server, Tftp Filename, Hpnp/printer1.cfg

Table 3-3Telnet Commands and Parameters (continued)

ipsec-config	NOTE: The ipsec-configcommand is available on print servers that support both
firewall-config	IPsec and Firewall configuration. The firewall-configcommand is available on full-
	featured print servers that do not support IPsec, but allow Firewall configuration.
	Disable IPsec or Firewall operation on the print server after IPsec/Firewall policies are
	configured and enabled. You cannot enable IPsec/Firewall operation using this
	command. Instead, use the HP Embedded Web Server to configure and enable IPsec/
	Firewall polices.
	0: Disable IPsec/Firewall operation.
	1: (Read Only) IPsec/Firewall policies are configured and enabled.
ip	IP address for the print server. For example:
	ip-config manual
	ip 192.168.45.39
	In the example, manual signifies manual configuration and ip sets the IP address on
	the print server.
	To clear the IP address, set the value to 0.0.0.0.
	If you change this IP address, you must use it on the next Telnet connection.
subnet-mask	Identify the network and host portions of an IPv4 address in received messages. For
	example:
	subnet-mask 255.255.255.0
	In the example, 255.255.255.0 is stored on the print server. To clear the subnet IP
	address and disable the mask, set the value to 0.0.0.0.
	NOTE: If the HP Jetdirect print server is configured by DHCP and you manually
	change the subnet mask or the default gateway address, you should also change the
	print server's IP address. This releases the assigned DHCP address back to the DHCP
	IP address pool.
default-gw	IP address of a default gateway used by the print server. For example:
	default-gw 192.168.40.1
	In the example, 192.168.40.1 is the IP address of the default gateway.
	NOTE: If the HP Jetdirect print server is configured by DHCP and you manually
	change the subnet mask or the default gateway address, you should also change the
	print server's IP address. This releases the assigned DHCP address back to the DHCP
	IP address pool.
parm-file	Path and file name whose contents are printed each time the print server is turned on.
	Enter up to 64 alphanumeric characters.
Config Server	(Read only.) IP address of the server (such as a BOOTP or DHCP server) that last
	configured the IP address on the HP Jetdirect print server.
TFTP Server	(Read only.) IP address of the TFTP server that provided parameters to the HP Jetdirect
	print server.
TFTP Filename	(Read only.) Path and TFTP filename on the TFTP server. For example:
	hpnp/printer1.cfg

ENWW IPv4 configuration 47