The procedure enables the RARP daemon running on your system to respond to an RARP request from the HP Jetdirect print server and to supply the IP address to the print server. Configure RARP using the following steps:
1.Turn the printer off.
2.Log onto your UNIX or Linux system as the super user.
3.Use the process status command to verify the RARP daemon is running on your system, as in the following example from the system prompt:
ps
ps ax grep rarpd (BSD or Linux)
4.The system response should be similar to the following:
861 0.00.2 24 72 5 14:03 0:00 rarpd
860 0.00.5 36 140 5 14:03 0:00 rarpd
5.If the RARP daemon is not running on the system (the process is not in the process list), see the rarpd man page for instructions about starting the daemon.
6.Edit the /etc/hosts file to add your designated IP address and node name for the HP Jetdirect print server, as in the following example:
192.168.45.39 laserjet1
7.Edit the /etc/ethers file (/etc/rarpd.conf file in
00:01:E6:a8:b0:00 laserjet1
NOTE: If your system uses Network Information Service (NIS), you need to incorporate changes to the NIS host and ethers databases.
8.Turn the printer on.
9.Verify that the card is configured with the correct IP address, by using the ping utility as in the following example:
ping <IP address>
In the example, <IP address> is the assigned address from RARP.
10.If ping does not respond, see Troubleshoot the HP Jetdirect print server on page 125.
Use the arp and ping commands (IPv4)
You can configure an HP Jetdirect print server with an IP address using the arp command from a supported system. The workstation from which the configuration is made must be located on the same network segment as the HP Jetdirect print server.
NOTE: If you are configuring an HP Jetdirect wireless print server, this section assumes that a wireless network connection is established.
38 Chapter 3 TCP/IP configuration | ENWW |