HP 640n Print Server manual Security, Ipsec, Firewall, Code Verification, CFG Link

Table C-2HP Jetdirect EIO Menu on Classic Control Panel (continued)

Menu Item	Description
SECURITY	Reset current security settings to factory defaults.
	KEEP (default): Retain current security settings.
	RESET: Reset security settings to factory defaults.
IPSEC	(Full featured print servers only) If the print server supports IPsec, IPSEC is displayed on the
or	menu for both IPsec and Firewall status. If the print server does not support IPsec, Firewall is
	displayed. Specify the state of IPsec/Firewall on the print server.
FIREWALL	Disable IPsec/Firewall.
	KEEP (default): Retain IPsec/Firewall operation as configured.
	DISABLE: Disable IPsec/Firewall operation.
802.1X	KEEP (default): Retain current 802.1X settings.
	RESET: Reset 802.1X settings to factory defaults.
CODE VERIFICATION	YES (default): Perform verification of the integrity and authenticity of the encrypted firmware
	upgrade image before installation. If an error is detected by the download manager, the
	configuration page displays a code verification error.
	NO: Do not perform verification of the firmware upgrade image.
PRINT	Print a configuration page for the selected item.
	PROTOCOLS: Print IPX/SPX, Novell NetWare, AppleTalk, or DLC/LLC configuration.
	SECURITY: Print the current security settings.
CFG LINK	Manually configure the HP Jetdirect print server's network link.
	NO (default): Bypass the link configuration menu.
	YES: Access the link configuration menu.
	Set the link speed and communication mode. These must match the network. The available
	settings depend on the print server model.
	CAUTION: Changing the link setting can cause the loss of network communication with the
	print server.
	AUTO (default): Use auto-negotiation to set the highest link speed and communication mode
	allowed. If auto-negotiation fails, either 100TX HALF or 10TX HALF is set depending on the
	detected link speed of the hub/switch port. (A 1000T half-duplex selection is not supported.)
	10T HALF: 10 Mbps, half-duplex operation.
	10T FULL: 10 Mbps, Full-duplex operation.
	100TX HALF: 100 Mbps, half-duplex operation.
	100TX FULL: 100 Mbps, full-duplex operation.
	100TX AUTO: Limits auto-negotiation to a maximum link speed of 100 Mbps.
	1000 FULL: 1000 Mbps, full-duplex operation.

ENWW Classic control panel EIO menus 191