HP 640n Print Server manual Psk-passphrase, Encryption, Wep-key-method, Wep-key 1 0123456789net

Table 3-3Telnet Commands and Parameters (continued)

psk-passphrase	Passphrase used to generate a network pre-shared key. A passphrase must be from 8
	to 63 ASCII characters in the hexadecimal range 21 through 7E (characters 0–9, a–z,
	A–Z and numerous special characters including !, @, #, $, %, ^, &, (, ), _, +, =, −, {, }, [, ],
	\, /, “, <, >, ?, “, ‘, ~).
encryption	Use encryption. 0 (default): Disable. 1: Enable.
wep-key-method	Format for WEP key entry. WEP key entries must be of the proper length.
	ASCII (default): Use alphanumeric ASCII characters (0–9, a–z, A–Z). For 40/64-bit
	encryption, enter 5 characters. For 104/128-bit encryption, enter 13 characters. ASCII
	entries are case-sensitive.
	HEX: Use hexadecimal digits (0–9, a–f, A–F). For 40/64-bit encryption, enter10
	hexadecimal digits. For 104/128-bit encryption, enter 26 hexadecimal digits. HEX entries
	are not case-sensitive.
wep-key	Static WEP encryption key. The print server can store up to four WEP keys using four
	key positions (Key 1, 2, 3, 4). To enter a WEP key, specify the key position followed by
	the encryption key value, as in the following example:
	wep-key 1 0123456789net
	In the example, Key 1 is assigned with a with a 128-bit WEP key specified by the value
	0123456789net.
	You can use the wep-key-methodcommand to specify the format of the key value
	(hexadecimal digits, or alphanumeric ASCII characters). Alternatively, you can insert an
	optional parameter (ASCII or HEX) after the key position, as in the following example:
	wep-key 1 ASCII 0123456789net
	In the example, Key 1 is assigned a 128-bit WEP key specified by the alphanumeric
	ASCII characters 0123456789net.
	When assigning static WEP keys, ensure that key positions and key values match other
	wireless devices on the network. Ensure that all key values entered are of the same
	length, and that WEP key lengths use the proper number of characters or digits.
transmit-key	WEP key position (1, 2, 3, 4) that the print server uses for encrypted communications,
	as in the following example:
	transmit-key 2
	In the example, Key 2 is used for encrypted communications, matching other devices on
	the network. The default value is 1.
dynamic-encrypt	802.1x dynamic encryption. Set to: NONE (default), BASIC, AUTO, WPA, or WPA2.
desired-channel	(Ad hoc only) Specify a desired channel that the print server uses for ad hoc network
	association requests. The default is channel 11.
	10: Use channel 10 (2457 MHz).
	11: Use Channel 11 (2462 MHz).
	The print server uses this channel to broadcast its availability if it fails to detect and
	associate with the specified ad hoc network on any channel.
dot11-switch-time	Specify the time (0 - 120 seconds) for the print server to enable its 802.11 wireless port
	when its 10/100TX wired port is disconnected from the network.

ENWW IPv4 configuration 45