HP 640n Print Server manual Other

Table 3-3Telnet Commands and Parameters (continued)

Status	(Read-only parameter.) Current AppleTalk configuration status.
	READY: HP Jetdirect print server is awaiting data.
	DISABLED: AppleTalk was manually disabled.
	INITIALIZING: Print server is registering the node address or name. An additional
	status message might also be displayed.
DLC/LLC
dlc/llc-config	Use DLC/LLC protocol operation on the print server (if supported).
	0: Disable.
	1 (default): Enable.
	NOTE: On HP Jetdirect 640n print servers, all network protocols except TCP/IP are
	disabled by factory default.
strict-8022	Controls DLC/LLC protocol interpretation:
	0 (default): Disable. Provide loose interpretation.
	1: Enable. Provide strict interpretation.
Other
upgrade	Set the name and location of the firmware upgrade file for the HP Jetdirect print servers.
	CAUTION: Ensure that command parameters are properly entered and that the
	upgrade file is a higher version than the currently installed version. The print server
	attempts to upgrade if the upgrade file contains a higher version than the installed
	version.
	The following is the command format:
	upgrade: <TFTP server IP> <Version> <Product Number> <Filename>
	The following defines the parameters:
	<TFTP Server IP> IP address of the TFTP server, <Version> firmware version of
	the upgrade file, <Product Number> print server product number <Filename> path
	and filename of the firmware upgrade file.
laa	Specify a locally administered address (LAA) to replace the factory-assigned LAN
	hardware (MAC) address. If LAA is used, enter a string of exactly 12 hexadecimal digits.
	For Ethernet print servers, the LAA must start with hexadecimal X2, X6, XA, or XE,
	where X is any hexadecimal digit 0 through F.
	The default address is the factory-assigned address.
xml-services-conf	Allow access by HP Web service applications to XML-based data on the HP Jetdirect
	print server.
	0: Disable.
	1 (default): Enable.
ws-discovery-conf	Allow Microsoft WS discovery protocols on the print server.
	1 (default): Enable.
	0: Disable.

ENWW IPv4 configuration 57