HP 640n Print Server Tftp Retries Exceeded, BAD BOOTP/DHCP Reply, BAD Bootp TAG Size, Dhcp NAK

Table 8-13Error messages (continued)

Error Code and Message		Description
51	TFTP RETRIES EXCEEDED	Retry limit exceeded when transferring the TFTP configuration file from the host to
		the HP Jetdirect print server.
52	BAD BOOTP/DHCP REPLY	Error detected in the BOOTP or DHCP reply received by the HP Jetdirect print server.
		The reply contains insufficient data in the UDP datagram for the minimum BOOTP/
		DHCP header of 236 bytes, has an operation field that is not BOOTPREPLY(0X02),
		has a header field that does not match the print servers hardware address, or
		contains a UDP source port that is not the BOOTP/DHCP server port (67/udp).
53	BAD BOOTP TAG SIZE	Tag size in a vendor-specific field in the BOOTP reply is either 0, or greater than the
		remaining number of unprocessed bytes in the vendor-specified area.
54	BOOTP/RARP IN PROGRESS	Print server is obtaining its basic IP configuration information through BOOTP/RARP.
55	BOOTP/DHCP IN PROGRESS	HP Jetdirect print server is obtaining its basic IP configuration information through
		BOOTP/DHCP (no errors detected).
56	DHCP NAK	Print server received a negative acknowledgement message from the DHCP server in
		response to a configuration request.
57	UNABLE TO CONNECT DHCP	The HP Jetdirect print server received IP parameters from a DHCP server, but
SVR		communication with the server is lost. Check status of the DHCP server.
		If an infinite lease is assigned, the print server uses the IP address of the most recent
		DHCP server. Operation can degrade until a DHCP server responds.
58	POSTSCRIPT MODE NOT	Printer does not support AppleTalk or AppleTalk extensions.
SELECTED
59	INCOMPLETE F/W - MUST	Currently downloading firmware to the HP Jetdirect print server, or the download did
DOWNLOAD		not complete properly.
5A TURN PRINTER OFF / ON		Firmware download is complete. Turn the HP Jetdirect print server off and then on.
5C DHCP BAD REPLY		Bad reply received from the DHCP server. Check your DHCP server settings for this
		print server.
5D DHCP LEASE DURATION TOO		DHCP lease times for this print server's TCP/IP configuration settings are too short.
SHORT		Re-configure the DHCP lease times on the DHCP server.
5E DHCP LEASE RELEASED		Lease parameters for DHCP, including the IP address, were released through a
		manual configuration method, such as the printer's control panel.
5F WINS REGISTRATION FAILED		Cannot register the print server's name on the WINS server. Check for duplicate
		names, or verify the WINS server configuration.
61	AUTO IP CONFIGURED	Cannot retrieve an IP address over the network. The print server defaults to an IP
		address using link-local addressing in the form 169.254.x.x.
62	DEFAULT IP CONFIGURED	Cannot retrieve an IP address over the network. The print server defaults to a legacy
		IP address 192.0.0.192.
63	AUTO IP IN PROGRESS	The print server is automatically assigning an IP address using link-local addressing
		in the form 169.254.x.x.
64	INVALID PASSWORD	An invalid password was specified through TFTP. Verify that the password consists of
		a maximum of 16 printable characters.
65	DOWNLOAD NOT ALLOWED	This print server does not allow firmware upgrade over a wireless network
ON WIRELESS		connection.
83	DISCONNECTING FROM	Server shut down because of a configuration change or reset request. This message
SERVER		automatically clears after a few seconds, unless the printer is offline, is in an error
		state, or is servicing another I/O port or another network protocol.

158 Chapter 8 HP Jetdirect configuration pages ENWW