HP 640n Print Server manual Device Announcement Agent

Table 4-18802.1X configuration settings (continued)

Item	Description
Authentication Behavior:	Control authentication when you click Apply on this page, assuming valid configuration
Reauthenticate on Apply	entries were made.
	NOTE: Does not apply to security or other configuration wizards. Changes to
	parameters through a wizard always causes the print server to re-authenticate.
	If disabled (default), the print server does not attempt re-authentication unless
	configuration changes cause the print server to disconnect and reconnect to the
	network.
	If enabled, the print server always attempts to re-authenticate using the configuration
	values.
Restore Defaults	Restore 802.1X configuration settings to factory default values.

IPsec/Firewall

Configure or view the IPsec or Firewall policy for the print server. You can enable or disable IPsec/ Firewall operation on the print server, and configure the default rule for IP packets that are not covered by IPsec/Firewall rules.

Rules that define the IPsec/Firewall policy are configured through an IPsec/Firewall wizard, which is run when you click Add Rules. For more information, see IPsec/Firewall configuration (V.45.xx.nn.xx) on page 105.

Device Announcement Agent

Use the Device Announcement page to enable or disable the HP Device Announcement Agent, to set the configuration server, and to indicate whether to require mutual authentication using certificates. When enabled (the default), the HP Device Announcement Agent sends an announcement to a configuration server when the device first connects to your network. The configuration server, such as the HP Imaging and Printing Security Center, then sends the pre- established configuration settings to the device.

By default, the device announcement agent is enabled, and mutual authentication (using certificates) is disabled.

Item	Description
Enable Device Announcement Agent	Select the check box to enable the device announcement
	agent. Clear this check box to disable the device
	announcement agent. (By default, the device announcement
	agent is enabled.)
Configuration Server IP Address (v4/v6)	The announcement agent uses the default DNS host name
	hp-print-mgmt to locate the configuration server. To override
	the host name, enter the configuration server's IP address.
Require Mutual Authentication via certificates	Select the check box to require authentication between this
	device and the configuration server.

102 Chapter 4 HP Embedded Web Server (V.45.xx.nn.xx) ENWW