HP 640n Print Server Ipx-mode, Pjl-banner, Ipx-banner, Pjl-eoj, Ipx-eoj, Pjl-toner-low, Appletalk

Table 3-3Telnet Commands and Parameters (continued)

ipx-sapinterval	Time in seconds that the HP Jetdirect print server waits between service advertising
	protocol (SAP) broadcasts on the network. Set from 1 to 3600 seconds.
	0: Disable.
	60 (default): Enable SAP broadcasts.
ipx-mode	(Read-only parameter.) NetWare mode configured on the print server (RPRINTER or
	QSERVER).
ipx-nds-tree	NDS tree name for the print server. Enter up to 31 alphanumeric characters.
ipx-nds-context	NDS context for the HP Jetdirect print server. Enter up to 256 alphanumeric characters.
ipx-job-poll	Specifies the time interval in seconds that the HP Jetdirect print server waits to check for
	print jobs in a print queue. Set from 1 to 255 seconds.
	0: Disable.
	2 (default): Enable.
pjl-banner	Print an IPX banner page through PJL.
(ipx-banner)	0: Disable.
	1 (default): Enable banner pages.
pjl-eoj	IPX end-of-job notification through PJL.
(ipx-eoj)	0: Disable.
	1 (default): Enable.
pjl-toner-low	IPX toner-low notification through PJL.
(ipx-toner-low)	0: Disable.
	1 (default): Enable.
AppleTalk
appletalk	Use AppleTalk (EtherTalk) protocol operation on the print server.
	0: Disable.
	1 (default): Enable.
	NOTE: On HP Jetdirect 640n print servers, all network protocols except TCP/IP are
	disabled by factory default.
Name	(Read-only parameter.) Name of the printer on the AppleTalk network. A number after
	the name indicates that this is the Nth instance of the name.
Print Type	(Read-only parameter.) AppleTalk network printer type reported by the HP Jetdirect print
	server. Up to three print types can be reported.
Zone	(Read-only parameter.) Name of the AppleTalk network zone on which the printer is
	located.
Phase	(Read-only parameter.) AppleTalk phase 2 (P2) is pre-configured on the HP Jetdirect
	print server.

56 Chapter 3 TCP/IP configuration ENWW