HP 640n Print Server manual Code Verification, Enable Wipe, LAN HW Test, Http Test

Table C-1HP Jetdirect EIO Menu on Graphical Control Panel (continued)

Menu item	Sub-menu item	Sub-menu item	Values and Description
	Code Verification		Yes (default): Perform verification of the integrity and
			authenticity of the encrypted firmware upgrade image
			before installation. If an error is detected by the
			download manager, the configuration page displays a
			code verification error.
			No: Do not perform verification of the firmware
			upgrade image.
	Enable Wipe		Most configuration settings are erased during a cold
			reset. However, you can indicate whether to also
			erase stored digital certificates.
			Yes: Erase all stored digital certificates during a cold
			reset.
			No (default): Do not erase stored digital certificates
			during a cold reset.
	Login Security		Keep
			Reset
	Assessment		Keep
			Disable
Diagnostics	Embedded Tests		(HP Jetdirect embedded print servers only.) Diagnose
			network hardware or TCP/IP network connection
			problems.
			Use an embedded test to check hardware and
			communication paths on the print server. After you
			select and enable a test and set the execution time,
			select Execute to initiate the test.
			Depending on the execution time, a selected test runs
			continuously until either the device is turned off, or an
			error occurs and a diagnostic page is printed.
		LAN HW Test	CAUTION: Running this embedded test erases your
			TCP/IP configuration.
			Performs an internal loopback test, which sends and
			receives packets only on the internal network
			hardware. There are no external transmissions.
			Yes: Select this test.
			No: Do not select this test.
		HTTP Test	Check operation of HTTP by retrieving predefined
			pages from the device, and test the HP Embedded
			Web Server.
			Yes: Select this test.
			No: Do not select this test.

ENWW Graphical control panel menus 185